UpstateMatthews

I run a set of tire chains that I got from a buddy that had them on his Chevy. Had to cut them down length wise to make them fit but they work great. If you're handy with a grinder and can weld it's pretty easy to modify them. Look on places like Craigslist or Facebook Marketplace, you can usually find a set that's not gonna kill you price wise.

Thank ya'll for all the help. I finally got it to cooperate. Yes they're were timing marks, once I figured out the alignment of those it went a lot smoother.

25 minutes ago, Mech said:

Have you looked in a manual ?  There might be a manual in the manuals section on this site.

There is one but I can't download it until I have ten approved posts.

I bought a couple LT230's and I'm trying to put an engine together but can't figure out the kick starter gear position.

If anyone could help out it would be greatly appreciated.

Good morning to all! Hope everyone has fun and stays safe out there.

I use Turtle Wax Hybrid Solutions Ceramic Spray on my plastics. Don't spray on your seat or hand grips, it makes them slippery.

On the engine I just get the majority of the mud off then use an automotive engine de-greaser like Gunk or Oil Eater.

As far as the harness just keep an eye out for any breaks and fix them immediately. If you can, wrap your harness in split loom wrap and make sure it's taped up real good. Also use some dielectric grease in your connectors, it's fairly inexpensive and helps prevent corrosion by keeping moisture out of the plugs.

I got into quads because I started working on lawnmowers and wanted to expand my knowledge.