Quantcast
Jump to content

wwdubose

Members
  • Posts

    1
  • Joined

  • Last visited

About wwdubose

  • Birthday 03/14/1962

wwdubose's Achievements

Newbie

Newbie (1/14)

  • First Post
  • Conversation Starter
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

10

Reputation

  1. I have two 2003 Suzuki Ozark 250s, both 2-wheel drive. Last time we rode them about a year ago, the red one was not running well, didn't want to idle, backfired a lot. The green one ran fine. Fast forward...I ordered a carb kit for both of them, thinking the red one has some trash in a jet. Both of these ATVs have had little use and I've always ran the gas out after use (put an inline cutoff valve in gas line). I pull started the red one to verify it was still running bad. It will start and idle, but as soon as you give it any throttle, it dies instantly. Give it a little choke, dies instantly. Took the carb apart and it was spotless. Went ahead and cleaned all the holes with carb cleaner and blew everything out with compressed air. All new jets, main jet holder, and needles. Put it back on and nothing changed. Starts, idles (not for a long time), but dies as soon as you give it gas. Same happens when you put the choke on. It does the same thing when I try to run it turned to prime on the petcock as it does in the on position. Not an air filter issue. It is clean and it does the same exact thing with no filter on it. Thought maybe there was a float issue or maybe a damaged diaphragm, so I took the carb off the green Ozark and put it on red. Started up and initially ran normal and revved for about 10 seconds and then started doing the same exact thing. Starts, idles (not for a long time), but dies as soon as you give it gas. Same happens when you put the choke on. So...not the carb Thought maybe vacuum petcock was bad, but there's no gas in the vacuum line going from petcock to carb and gas flows freely when on prime. I even plugged the vacuum line at both the petcock and carb end and tried to run it with valve set to prime. Gas flows freely, but does exactly the same thing. I unscrewed the screw at the bottom of the bowl and gas flows thru carb and out bowl drain line when petcock is set to prime. So, I'm assuming petcock is good? Checked spark plug and it wasn't fouled. Reset gap, didn't help. Will swap plugs between Ozarks tomorrow but I don't think that is it. Anyway, that he history and now you're all caught up. Scratching my head. Valves? These were bought at same time and have had little use. Suggestions? Thanks!
  2. wwdubose

    wwdubose

×
×
  • Create New...