Kawasakibayounospark
-
Posts
23 -
Joined
-
Last visited
Content Type
Profiles
Forum
Gallery
ATV Magazine
Events Calendar
Downloads
Store
Community Map
Posts posted by Kawasakibayounospark
-
-
Both of mine read 0 in no crank or cranking new one should be here anytime will let you know how that ends up
- 1
-
Both of mine read 0 in no crank or cranking new one should be here anytime will let you know how that ends up
-
And that's ohms or voltage
-
The small conector is the pins I tried to ohm they go directly to the pickup coil
-
-
Will do in the am
-
Striped the harness all looks good
-
Agree but that coil should have power if everything else is working
-
I did change the regulator with original cause I read that else were. It was running in my garage one day and just d ied and now we're here there isn't much else to check is there I still don't understand why I don't get oms on the pickup coil I have another pickup coil comming along with cdi box there not factory but yet another manufacturer than the others I have bought at that point I can't see have that many parts with the same problem
-
Oven trick didn't work
-
29 minutes ago, Frank Angerano said:
Ok well hopefully it was all installed properly and a non defective coil. The oem cdi you have is that the only one you have ? Orignal ? I’ve learned that most of the time the cdi will not work with any moisture what so ever. Aftermarket ones do not work well or at thays why I recommend oem cdis. If so try to heat that one up in the oven. It works! Not as a final fix but at least It will let you know that the cdi is bad.
-
I would also buy a cdi from kawasaki but want to be sure cause it's almost five hundred dollars
-
Pick up coil was replaced with stator
-
I have no reading on the pickup coil at any time old or new tryed it wit engine crank and out of machine. But dhould that send power form cdi or just ground
-
I don't see my post about cdi box I is original 2are aftermarket from two different companies
-
What's the pick up coil suppose to do with an ohm meter I don't ever get a reading
-
Kill switch is working like it should
-
Coil is new also but no power to the coil at any time
-
I have key power to the cdi box so I would assume the kill switch is working but will do a quick test to be sure
-
Stator coil has been replaced. I am stumped
-
Repaced it
-
any one know much about how this system works. Replaced voltage regulator cid box coil pickup coil have power to cid box none out to coil any thoughts. This is cid box number three
Kawasaki bayou 400 no spark
in Kawasaki ATV Forum
Posted
No damage to the one in I already had it out but I will let ya know how it turns out