Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Goose1963

2006 YFM25BV service manual

Recommended Posts

So I got this ATV for free. The owner said it made a noise  when it was being started. So he was putting new valves in it. He also mentioned something about a shear pin on the gear for the timing chain?.. So before I start to reassemble this jigsaw puzzle any other possible checks I can make so I don’t have to tear this back down. Any thoughts or ideas would be great. Thanks in advance

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Gordon cousins
      I have a 1991 Big Bear 4x4   Shifter on top. Any one know if a  1994 Big Bear 4x4 Shifter on motor can be swapped 
    • By Adrian Ciotinga
      So I’ve had this quad for the better part of a month, and it’s been hard to start since the day I bought it. Once it warms up it idles just fine and has plenty of power and starts no problem, but cold it takes 20 seconds minimum of straight cranking to start it.
      It’s not really too big of an issue, I’m just curious as to why it takes so long. Earlier today, it took me about 2 minutes of on/off cranking to get it to fire.
      i have attached a video of a cold start to show you what I mean.
      FullSizeRender.mov
    • By YamahaGrizzly
      Billy went all out and bought N2deep Snorkels, Rubber Down customs Rad kit and Rox speed fx Risers for his Grizzly 700. It took a solid 3 days in the shed to install all this new gear on Billys Yamaha grizzly 700! We cant wait for the next time we get out and go on a run! should be this week actually! gonna be good to get the Yamahas grizzlys and Kodiak together!
    • By mothrottle
      Does a US made grease gun fit Metric zerk fittings, or do I need a conversion to fit them?  Thanks in advance.
    • By Adrian Ciotinga
      Hello,
      I recently picked up an ‘07 KFX 700. All was going well, rode it about 40 miles, when it started bogging at low speeds. If I kept the revs higher, I was just fine. Also, a persistent issue since I picked it up is the fairly difficult start (but it is abnormally cold right now and the quad is jetted for the dunes at summertime).
      Regarding the complete lack of idle, I have to rev it a couple times to get it to idle after starting it, after which it’s 50/50 whether it remains idling. I don’t have low fuel, but all of this began after I rode it pretty hard and the radiator fan kicked in. Might be overheating, just wanted to hear your opinions.
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...