Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Matthew Richards

new head adjustments

Recommended Posts

I have a 2002 Yamaha Warrior 350 and i have a couple questions

1) On a brand new head would the valve clearances be set out of the box or would they need set?, bc i dont have a gauge and need to know weather or not to get one.

2) Will a brand new head come with valve covers and timing chain side plate?

 

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Asen_77
      Hi All,
      My name is Asen and I am from Eastern Europe, Bulgaria. Riding a Yamaha Raptor 700R and this is my first Quad wanted for a vey long time :)

       
    • By Andrew520
      Got a good deal on an 89 bayou 300. Couple questions. First is in the picture I have posted. Note the two wires at the bottom of the pic (white and black/yellow). They were not hooked up to anything and Im not sure if they are supposed to go to the battery or somewhere else and what they are for.
      Second question is I had the carb apart for a cleaning. The vaccum operated slide has a spring under the cap with a plastic clip that goes inside the spring. Is there a proper location inside the spring for that clip. Right now it is just below half way inside the spring.
      It runs alright but keeps fouling the plug. Pulled the plug off, cleaned it and dried it off and it starts back up but not sure how long before itll do it again, last time it was about 20 minutes of riding and it bogged out and wouldnt start.

    • By Gordon cousins
      I have a 1991 Big Bear 4x4   Shifter on top. Any one know if a  1994 Big Bear 4x4 Shifter on motor can be swapped 
    • By StolenATV
      Taken from my car port around 0330 and was taken by at least 2 people found footprints pushing the quad all the way to the road (80 yards)
      The post 2012 Yamaha Grizzly 700 EFI 4×4 Stolen appeared first on STOLEN 911.
      View the full article
    • By K L Buck Naff
      Trying to replace the carburetor on my 2003 Bear Tracker 250. Two brand new carbs in a row from different suppliers.   Both leak fuel out over flow and intake as soon as I turn the gas on. Any ideas. Am I doing something wrong?
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...