Quantcast
Jump to content

joshuad508

Members
  • Posts

    2
  • Joined

  • Last visited

About joshuad508

  • Birthday 02/05/1983

joshuad508's Achievements

Newbie

Newbie (1/14)

  • First Post
  • Week One Done
  • One Month Later
  • One Year In
  • Conversation Starter

Recent Badges

10

Reputation

  1. joshuad508

    joshuad508

  2. ok thanks for no help lol. I figured it out. there was a bad connection to the diag wire on the plug for the speedo if I wiggled the plug I would notice the 4wd light go on and off. so I pushed it in real hard and the 4wd light stood on. then I jumped the diag wired and I was able to read codes.
  3. I just bought this quad and I replaced the speedometer. The quad runs fine. but the efi starts blinking telling me there is a code but when I jump the wires the codes don't show up. am I jumping the wrong wires? I checked the diagnostic wire between the computer and the speedometer and it checked out fine. I also checked the 4 wires that are on the diagnostic connector they were also fine. has anybody had this problem.
×
×
  • Create New...