Ok everyone, I've been rebuilding the top end of my vinson 500 and here is my problem. After replacing all the gaskets and getting my timing set I was all set to place the head on when I realized I had left one of the two small sleeves that position the cylinder head on the base. To go back and put it in would require another complete tear down. This is one of those round cylindrical tubes that the jug sits on. All bolts are in along with Indian head gasket shellac on both sides of the gasket, my question is what might it hurt if I don't put it back in? Honestly I can't see where it will matter and setting the timing on this machine is a real bi***. Anyone have any thoughts on this?
Sent from my iPhone using Tapatalk
