03-400-4x4

I swapped the old one from defective magnet flywheel to new one and didn’t think twice that I could’ve put it on backwards but I don’t remember any marking or obvious way it went on..if I had put on backwards the motor wouldn’t have turned over with the starter at all as it’s a one way.... Sent from my iPhone using Tapatalk

Wonder why it worked a few times then quit... I did have a hard time seating the flywheel when installing it and it didnt seem seated super square on the crank until putting a wrench to it..I ordered a caltric ebay one with another cover gasket so fun times await this weekend... Do you know if the new part has markings like "this way towards motor" ? I heard they can be installed backwards and i dont need to take this thing apart again... Sent from my LG-M322 using Tapatalk

I agree starter is good. I’m wondering how to diagnose starter clutch without pulling side cover again by trying to understand if the idler gear should move in both directions because it is geared to that starter clutch which is a one way bearing..obviously if it’s bad I’ve got to get back into the case again...but it would be nice to know it’s bad so I can order a new one and avoid down time on the machine bc it still pull starts fine.. Sent from my iPhone using Tapatalk

Unless I’m way wrong I don’t believe these starters engage in and out like an automobile starter- the starter clutch does that...the starter does spin when installed and when bench tested.. Sent from my iPhone using Tapatalk

Recently cracked cover and changed out bad flywheel and stator (manual tranny)— reused original one way starter clutch..quad started fine using starter a few times and now starter is free wheeling.. removed starter and starter is good— can feel idler gear inside starter hole spinning free in either direction.. Sent from my iPhone using Tapatalk

Have you ever replaced the flywheel? If not your magnets may have let loose.. I have save machjne and just had same symptoms and 2 magnets came loose..pm me for cheap parts list if needed. Sent from my iPhone using Tapatalk