Quantcast
Jump to content

MWrider

Members
  • Posts

    3
  • Joined

  • Last visited

Everything posted by MWrider

  1. Could also be needing the valves adjusted. Kind of a PITA to get feeler gauge in there. Come to find out that the valve adjustment screw pitch was .5 mm, ( checked with a thread pitch gauge). Easy then, after making a 3 mm end wrench for the screw. Set to TDC. Back off lock nuts. Turn screw until it touches valve. Back off screw required amount. Tighten lock nut. Mine were intake .05mm and exhaust .09mm. So, for the intake, I backed it off 1/10 turn. Could not, for the life of me, get my fat fingers and feeler gauge in there to do it.
  2. From what I read, these Tao Tao 4 stroke 110 / 125 cc motors have a lot of electrical problems. I bought a whole kit of electrical components, (reg, solenoid, ign switch, coil, cdi box, pickup and coils, wiring harness, etc) for $36, just to have them, (cheap insurance). Mine is charging at about 13.5V. Got a 49cc and this one for the Grandkids. Fair enough designs, just typical Chinese stuff that needs to be gone through.
  3. I picked up a Uplus EBZ7-3-2, 12v 6ah battery from Amazon for $24 shipped. Fits our ATA125-D Tao Tao and works good. Had to charge it before usewith my 1.5A battery tender, as it was low on charge when received. After charging, shows 233 CCA on my battery tester. Does not need the battery to run; just to start. I disconnected the battery after starting to verify.
×
×
  • Create New...