CaptJim

Oops! That wire is Red w/ Black stripe that I have connected to the Red w/ Black stripe on the CDI. Also not sure how to get into the manuals, don't think I have enough posts yet? You guys are the greatest for helping, Hope to be able to return the favor sometime.

Mech, the wires coming out of the motor (stator) are; Yellow - I have attached to the rectifier yellow Yellow - I have attached to the rectifier white wire Green - I have attached to green ground wire Red with Red stripe - I have attached to CDI red w/ black stripe Blue w/ white stripe - I have attached to CDI blue w/ white stripe\ The other wires coming out of the motor next to the stator wires are the ones I have questions about. They seem to be coming from a molded black cylindrical object that is held in place with an anchored clip and they are: Green w black stripe Blue w/ red stripe Purple Pink Light green w/ red stripe Thanks again for the help!

Guys, One other question... all the schematics that I am looking at show an emergency kill switch. I have no such switch that I can find, do I need one? Again, thanks in advance, not sure where else I could get such advice and knowledge.

Gwbarn, There are five other wires that also come from the stator that I believe go to the CDI and Regulator. These wires go to a cylinder just inside the engine below the starter motor.

Mech, The engine came from a trashed ( literally pulled it from a trash pile ) Kazuma ATV , here is the only number that I have found but cannot find anything to reference it to... It does have an electric start, and I think I have figured out the five wires coming out of the stator but have no idea what the other 5 wires from the green connector go to. About the front end... yeah, I realize that it is probably a little light, but it is what I had. besides, I'm 75 years old and won't be doing any jumps or wheelies. If I can find a smaller springer style front end at a swap meet, I will change it but until iI get it running this is a low budget project. Thanks again for the help and advice.

I should probably mention that the engine is a generic Chinese built 110cc engine. not sure exactly what it came from.🤥

Hello guys, I hope I am not invading your space, but as you can see the current state of my project here it's not but about 50% ATV. I am hoping that some one here can point me to a wiring schematic that I can reference since the "Complete wiring harness" i purchased from Amazon did not include a diagram of any kind. The ones that I am finding on line vary greatly but none show the connections for the separate 5 wire connector coming from the motor. Can someone tell me where these wires go? Thanks in advance for all help!