88bigbear

Bought a 88 big bear 350 4x4 took it for a run and lost spark, found it was stator so I replaced that then took it for a long run and it sat for 2 days and no spark again, this time stator tests good on ohms and voltage for source and pick up coils so I started replacing things including regulator, ignition, ignition coil and plug cap, spark plug and everything tests great including all safety switches until the orange wire for ignition coil from the cdi it only reads 3 volts so I replaced the cdi and still 3 volts, any ideas??

I know this thread is old but I have a 88 big bear no spark, replaced stator and coils regained spark took for long ride then lost spark again all resistance and voltage tests good Iv replaced regulator, ignition coil, plug cap, plug, ignition, tested killswitch and neutral switch still no spark, only getting 3 volts to orange wire from cdi to coil so replaced cdi and it was still the same any ideas?