Quantcast
Jump to content

Recommended Posts

Posted

I am restoring two ATV for my bro-in-law and don't have the owners manual...I do have the service manual.

1- when I turn the key to the ON position and the motor NOT running or running....the thermostat light (red light in lower right corner of dash) is on right from the get go....is that normal? 

I suspect that should be off and comes one when the motor is overheating.

NOTE: the fan did come on after driving around a bit.

If that is not normal, what would cause that to be on as soon as the motor is started? Faulty temp/fan switch?

 

2 - what is the cheapest source for the various parts? I am looking for a speedo cable, and some various screws that hold the fuel tank cover and its side panels on as well as some of the small screw/bolts that hold the front fender.

also looking for some of the speedo gasket and dampers

DAMPER 34114-09F00 (looks like a gasket
DAMPER 34188-09F00 (looks like a rubber bushing and spacer)
 
 
Thanks in advance.
  • 3 weeks later...
Posted

Why am I not getting responses? grrr

so the red light issue is fixed...used a multimeter set to continuity and I had continuity on a cold temp sender...bought a new one and the red light is gone...I haven't tested the new one in a pot of boiling water yet, but suspect it is fine.

 

finding that the suzuki parts are bloody expensive...ebay seems to be the cheapest source.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Forum Topics

    • By cavry
      O3 sat a while. Engine is running fine. I got it into neutral, did some general tune-up and cleaning then pulled the shifter pedal up and it locked up and will not release into neutral again.  Does anyone have experience with this problem?  Thanks for looking and any help.
      Cavry
    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By flyinbrian365
      View File 2023 Yamaha RMAX4 Wolverine 1000 service manual
      Factory service manual
      2023 Yamaha RMAX4 Wolverine service manual
      Submitter flyinbrian365 Submitted 06/08/2026 Category Yamaha UTV  
    • By flyinbrian365
      View File 2021-22 Yamaha RMAX4 1000 Wolverine service manual
      Factory service manual
      2021-22 Yamaha RMAX4 1000 Wolverine service manual
      Submitter flyinbrian365 Submitted 06/08/2026 Category Yamaha UTV  
    • By flyinbrian365
      View File 2024-2025 Polaris Ranger XD 1500 service manual
      2024-2025 Polaris Ranger XD 1500 – Official service manual Resource
      What's Covered:
      This service manual covers complete OEM factory procedures for the following models:
      Polaris Ranger XD 1500 (2024–2025) Polaris Ranger XD 1500 Crew (2024–2025) Polaris Ranger XD 1500 NorthStar / Premium / Trail Boss variants (where applicable) Manual Contents Include:
      Engine service & specifications (ProStar 1500 Flex-Fuel engine) Fuel system diagnostics & EFI troubleshooting Drivetrain, transmission, and AWD/4WD service procedures Electrical system schematics & wiring diagrams Suspension, steering, and brake system specs Clutch adjustment, belt service, and CVT procedures Ride Command infotainment system & digital cluster diagnostics Torque specs, fluid capacities, and maintenance schedules Diagnostic trouble codes (DTCs) and service tool usage Towing & payload system specifications (2,500 lb tow / 1,500 lb payload) Intended Audience:
      This resource is for owners, farm & ranch operators, fleet maintainers, and professional technicians working on the 2024–2025 Ranger XD 1500 platform. Whether you're performing routine fluid services, chasing an electrical fault, or overhauling the drivetrain on a high-hour work machine, this manual provides the factory-spec procedures to get it done correctly the first time.
      Submitter flyinbrian365 Submitted 06/04/2026 Category Polaris UTV  
×
×
  • Create New...