Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By colin james
View File 2017-2019 sportsman 450/570 with eps factory service manual
This is the factory service manual for the 2017-2019 factory service manual for the sportsman 450/570 with electronic power steering
Submitter colin james Submitted 09/06/2018 Category Polaris ATV
The 2020 ATV Motocross National Championship (ATVMX) Series, an AMA National Championship, season finale would take place at South of the Border MX (SOBMX) in Hamer, South Carolina. SOBMX would be the round where the 2020 season would come to a close after a lengthy season that once again saw Wienen Motorsports/Yamaha/Maxxis’ Chad Wienen and Phoenix Racing Honda/Maxxis/Elka’s Joel Hetrick locked in a championship points battle until the end.
View the full article
Below is a quote from a response to similar question from yesterday:
"Easiest thing to check is trash in the main jet. if it idles fine, then the idle circuit and low speed jet is clear. if it bogs off idle that's when it's transitioning to the main jet."
I will go ahead and open up the carb and check the main jet, but please respond to this post as if the main jet is squeaky clean.
Below is my post:
Only starts and runs on Full chock.
Does not matter what position I have my "mixture" screw. Tried it at zero, 1 turn, 2 turn, up to five turns. Spent a few hours confirming that the position of the mixture screw does not resolve issue.
Runs great at idle and if I slowly engage throttle, it will rev up as expected. But, quick rev up or when I am trying to drive it, it spits and sputters and looses power.
I also use a propane bottle and did not find any obvious leaks, and the vacuum port is hooked to fuel peacock and I also made sure to simply block the port with my finger to see if that would resolve the issue.
New Carb (after market), New Coil, Fresh Gas. No leaks at manifold boot, hot battery. Good gas flow. Runs too good to be a valve issue, or cylinder, great compression.
I can move the choke out a tiny bit, and it will still run, but will still bog down when I try to power it up.
I also have a 250 trail boss Polaris that I require to run at full choke, but it has power at all throttle potions.
I suspect it is running rich as the choke is on, but will not run with it off.
Any details would be appreciated.
Three Palms Action Sports Park in Conroe Texas would host the first doubleheader in the 2020 ATV Motocross National Championship (ATVMX) Series, an AMA National Championship, on September 19 and 20.
View the full article
Recently Browsing 0 members
No registered users viewing this page.