Quantcast
Jump to content

Recommended Posts

Posted

Trouble finding 24mm bearing for the top mounting bolt of my 2008 YFZ450 Special Edition ATV rear shock. Most bearings kits sold are 27mm. Anybody know where I can get this bearing? I am specifically searching to find the bearing kit for the top of the shock absorber. Tried Pivot Works 52-0792 as well as All Balls 29-5043, but both come with 27mm outside diameter needle bearing where my ATV uses a 24mm bearing. Yamaha does not sell this replacement bearing, instead they suggest buying a new shock absorber entirely, which I think is ridiculous. I had a friend remove bearing from a similar ATV, photo of which I have attached. Any help is greatly appreciated.20220222_131631.thumb.jpg.f30b0b6d127eee27a02be5971f618b2a.jpg

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Otter9099
      I plan on using my ATV to hunt. What have you found to be the best method for carrying your rifle that is secure and allows removing quickly to pursue an animal?
    • By jen
      Cannot find out why 12 vdc  4 (4) commutator starter motor has no power. It will run full speed without load. But with any load will not turn. Repaired broken brush holder and insulated an internal wire to magnet that was bare and rubbing. cleaned commutator segments. Ohm readings while slowly rotating commutator was 1 ohm.   When attempting to run  with load it will not turn and Bat vdc only pulls down to12vdc. Cannot find an internal wiring schematic.  I can buy a rebuild kit ~$35 but WTH?

    • By Joeguy
      I randomly got the urge to rebuild my quad and seem to have lost my nuts and washers for mounting the head somehow. Has anyone replaced them with just some normal hardware from a local store and had luck? Really im just worried about the washer thickness and the depth of the acorn cap nuts.  I found some used sets on ebay but they want like 20+ dollars for em and then id have to wait for shipping aswell, trying to get it done before we get too much snow. 
      I am also just going to keep looking around as i know i have seen them recently, i just must have moved them to keep em safe one day and forgot where i stuck em.
    • By Ejwill
      I rebuilt the top end on my 2007 Honda Trx500fe. It ran fine right after the rebuilt. But now when I try to crank it it blows Bach through the carburetor. I held my hand over the opening for the intake air and it blew gas back on my hand. Can figure out what happened all of a sudden. It was cranking and was able to ride it running through all the gears. Now can get it to crank just blowing gas back to the air filter. Need help again. Starting to think I should have walked away from this one.
    • By Matdum
      Is there a common trouble to have the connecting rod bearing failure on a 2006 330 polaris magnum ? I have one who have failed and i want to know if there is something to check specifically
       
      thanks a lot !
×
×
  • Create New...