Quantcast
Jump to content

Recommended Posts

Posted

2006 rancher 350 Trx350te will not shift with electric shifter or with the manual emergency shifter. Could something in the electric shifter stop the manual shifter from shifting also? Should I start there? Thanks for any help.

Posted

Was the engine running or were you rocking the bike back and forwards, as you tried shifting with the manual shifter ?

They generally won't change gear manually if the engines turned off unless you rock them.

To diagnose what's wrong with the electric shift you need to download the service manual and have a read, and then start following the diagnostic process they lay out. An early check is to see if the dash is flashing at you, and then to read the stored trouble codes which give an indication of which bit isn't operating correctly. Then you check the indicated bit, and it's wiring, and all and any bit's indicated as not operating correctly, before deciding which bit is the cause and which are not operating correctly as a result.

  • Thanks 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Joeguy
      After i did my rebuild it seems to not want to shift well. I think the cable is alright, and when it does shift its nice and solid. I have to basically use my hand to shift and i have to pull or push it very far, like max travel, to get it to shift. I also tried adjusting the clutch set screw. Any ideas where to go next, or maybe i should just grab a new cable to try.
    • By jimbo69
      my outlander 800 sometmes starts and does good ouker times starts but will not idle .any one else have same problem?
       
    • By cavry
      O3 sat a while. Engine is running fine. I got it into neutral, did some general tune-up and cleaning then pulled the shifter pedal up and it locked up and will not release into neutral again.  Does anyone have experience with this problem?  Thanks for looking and any help.
      Cavry
    • By realpilot
      I am unable to find a wiring diagram for this UTV.  When I turn the switch to on, the contractor does not engage.  The Brake pressure switch and the parking brake switches work correctly. What else should I be looking for?  All of the diagrams I have found are for newer models and the wire color coding is different.
       
      Thanks
    • By Cj Winds
      I have a 2009 Honda Rancher TRX420FA with shifting problems.
      Usually it shifts ok when cold but after couple minutes it will stop shifting with no codes.
      The 1st shift clutch oil pressure when in first gear is 74psi. The 2nd shift clutch oil pressure when in second gear is 74psi.
      The 1st shift clutch oil pressure when in neutral is zero. The problem is when the tranny is in neutral the 2nd shift clutch pressure starts around 10-15psi and builds to 20psi. Is this normal?
×
×
  • Create New...