Quadzilla 300

[Memphis]

Not sure if in right place but here goes

My 300 is lacking power only reaching 30mph and struggling uphill everything else seems ok other that this problem cleaned all fuel new filter pan and all new fuel pump and spark plug full oil change is there anything I am missing

ps It is auto and does noy seem to want to get in another gear 5200 rpm at 30mph

 

Regards

[Mech]

I'd suspect that "auto" is really a variable ratio/diameter set of pulleys and a belt. One of the pulleys will either be moving apart  to the shrink the effective pulley diameter, or, not separating when it is meant to be separating, and so causing the high revs and no top speed.

The struggling up hill might correct itself if you fix the pulley problem. Does the engine seem to have full power when it accelerates away from a standstill, or perhaps at mid speed it might perhaps to have full power ? If it seems to have full power at some speeds (the speeds the ratio it's stuck in suits), and if it isn't actually missing uphill, then I'd concentrat5e on getting the belt drive cured.

[Memphis]

No it seems to pull away slowly than I would suspect also when it is struggling uphill I can release the throttle almost half way before the speed drops anymore ,

Sorry for late reply only just found your message 

Paul

[Mech]

It sounds like the variable ratio belt drive system is playing up. You aren't mentioning missing or backfiring or cutting out or anything that suggests the engine isn't running fine, and those symptoms could be caused by the bike being stuck in a high ratio.. I'd look there first..

[Memphis]

Thanks I will do,

If any different it won't tick over either cuts out or revs high very hard to go slowly over rough ground 

[Memphis]

Thank you Mech

Was the pulleys not opening all clogged up just got to balance the carb of now and hope it's all done 👍