Quantcast
Jump to content

Recommended Posts

Posted

I ordered a Caltric replacement for an Outlander 800 2006-2012 and just drilled a 3rd hole where the 2007 DS250 bracket lined up. It is close to the top hole predrilled, but is plenty of metal in between. I then tapped it to the bolt thread. Perfect fit

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Forum Topics

    • By noticon75
      Anyone ride at in the north east Kansas area? Tuttle Creek, Milford lake areas, Topeka?
    • By Elk
      2002 Polaris Magnum 325
      How to replace throttle assembly spring?
    • By Maxg_57
      Is anyone still active on this club
    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • By toe420
      Anyone here from BC? Where do you ride? 
×
×
  • Create New...