PLEASE lol does anyone know where I can find .......
-
Similar Forum Topics
-
By Jdeaton011989
Hi all. I have a timberwolf 250 2nd that will not start.. I thought it was out of time bc the guy I got it from said it just quit on him. The tensioner had a nut welded to it and it was like2 teeth off. I installed new tensioner and chain and it still will not start. It has fire and it will not hit off brake cleaner. It has compression. Haven't put a gauge but I'm sure it will crank and run with what it has. I double checked my work and it's still in time. Spot on. Both valves move. I'm about to put a feeler gauge on them and I'll cone back but other than that any ideas?
-
By tflack500tbx
Background,
This winter (Dec.) I was plowing and everything just died, just quit. No lights, no pull start, No nothing. I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this. So I changed it again, thinking this was the same problem. Tried to start it and a small pin hole in the CDI appeared with electrical smoke.
Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues). I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.
Went to start it and the solenoid rapidly clicked. All the dash lights on, headlights work. Pull stared it and it fired right up no issues. Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery. Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good. Pushed the starter button and it fired right up ran great. Turned it off to test it again, Turned the key and nothing. No dash lights nothing. Took the jump box off and pulled started it. Started it right up. Re-hooked the jump box, still nothing.
Any Ideas?
-
By Arizona
Just recently bought a dead 06 Eiger, Can someone post or send me a wiring diagram for it:?
Need to check all wires, no power in most places, Cant seem to read the ones from online manual,
too blury and cant tell wire color. Just too small. Thanks Az
-
By Peisledder
Hello, can someone help me? I have a MAP error code 102-3, and the MAP has 4 wires: light blue, orange, purple, yellow. I’m getting different results on what the wires are. I don’t have wiring diagram. Can someone confirm which is ground, 5v, MAP, and Temperature?
-
By davefrombc
1992-98 Yamaha YFB250 Timberwolf 2WD service manual
View File Service/Repair manual 1992-98 Yamaha YFB250 Timberwolf 2WD
Submitter davefrombc Submitted 08/06/2017 Category Yamaha ATV
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.