You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Bucking started about a month ago and works ok after 1/2 hour warmup. Today while working on it i discovered that if i put the ignition switch in LIGHT position it runs fine right from the start.
I'm stumped! Any idea why this could be?
The gas in the tank was bad so I drained it and put new fuel in. It still wouldn't run so I took the carb out and cleaned it. Re-installed the carb and now it will only start and run under full throttle. It also runs rough like this. The engine stops running once I back out to 1/4 throttle. What the heck is going on?
My 300ex won't run unless hooked to jumper cables or to a battery charger. When I try to rev it up it gets quieter instead of louder, is the stator bad? Could a CDI cause this? Could something with the ignition cause this? The neutral light only comes on when hooked to a power source and goes off as soon as the power source is connected. After I disconnect it from a power source it'll run for a few minutes then die. It'll also pull start but pushing the gas nothing happens, the choke isn't on and the gas isn't on reserve. My friend thinks it may be a stator because after I charged the battery and went to ride it the other day the battery was drained again. Any help would be appreciated as I'm lost and don't know where to start
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.