Quantcast
Jump to content

Recommended Posts

Posted

My TRX300 only sparks when I left off of the starter button. Installed new coil, new pulse generator{pick-up}, cleaned starter button with contact cleaner the best that I could{sealed unit}, stator looks and smells good, no burnt coils, tested 3 leads from stator for continuity- it tested good, checked it to ground and nothing shorted or cut. Resistance tested very low @ .003ohms unit out of bike. Put back together and still spark on;y when I let off starter button. Also the bike used to kick start easy, now it wont. Help!

Posted

Yes there is a Kill switch and it works. My battery is very low, but I was jumping it with a jump box. So the system still sees 12v. Would the primary low battery make a difference if I was jumping with a jump box? Thx. Once I start the bike it runs fine.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By logray
      Hi all, 

      I am wondering if any of you have a Clutch Starter gear from a 1988 era quadrunner 250 sitting around that you could get me a precise measurement of the outer diameter of the race the sprag engages onto, for me? I need to machine a damaged race down and install a hardened sleeve and need that measurement (it's on a different gear than the OEM one, so I can't buy and use a OEM gear). 

    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By TomJulio
      My 1992 TRX00 recently stopped firing.  I understand this is a common problem. I have ordered an aftermarket CDI unit.    TJ
    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
×
×
  • Create New...