Quantcast
Jump to content

Recommended Posts

Posted

My TRX300 only sparks when I left off of the starter button. Installed new coil, new pulse generator{pick-up}, cleaned starter button with contact cleaner the best that I could{sealed unit}, stator looks and smells good, no burnt coils, tested 3 leads from stator for continuity- it tested good, checked it to ground and nothing shorted or cut. Resistance tested very low @ .003ohms unit out of bike. Put back together and still spark on;y when I let off starter button. Also the bike used to kick start easy, now it wont. Help!

Posted

Yes there is a Kill switch and it works. My battery is very low, but I was jumping it with a jump box. So the system still sees 12v. Would the primary low battery make a difference if I was jumping with a jump box? Thx. Once I start the bike it runs fine.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By TomJulio
      My 1992 TRX00 recently stopped firing.  I understand this is a common problem. I have ordered an aftermarket CDI unit.    TJ
    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By crankin
      I have a 1997 Yamaha Big Bear 350 4x4. It used to start right up. Then all of a sudden it wouldn't crank. I have a schematic for it so I started tracing the problem. I had no power at the starter solenoid. According to the schematic the power comes from the neutral switch and through the starter circuit cut out relay. I cannot locate the cut out relay on this machine.. If I apply power to the relay it will crank with the start button.
      The neutral switch is hard to get to with all the brackets on this thing. I did find out from all my research that if I apply the rear brake lever it will start.
      Does anybody know if the cut out relay exists and where it might be found?
    • By Rockbottom
      Replaced stator now red reverse light stays on in all forward gears and when neutral light in on 
      When put in reverse the light goes out
      any ideas how to correct
      thanks ahead
       
       
×
×
  • Create New...