Quantcast
Jump to content

Recommended Posts

Posted

i have a 99 warrior and i am wanting to do the rear shock swap with a raptor 660 shock, has anyone done this that can tell me if all i need is the shock and its direct replacement or what all do i need? im a BIG rider and my poor lil warrior is low in the rear.. i read that i can upgrade to the rap660 shock and it will help alot..

any help is appreciated.. thanks

Posted

probably best to compare both shocks side by side to make sure it will bolt on without any mods, i'm really not sure if it's a easy swap out or not. a talkative mechanic at the yamaha shop might be able to tell you best ....

Posted

did some research, all rear shocks off raptor660 will fit, but if its piggyback shock you have to cut air box for it to fit, so the shock from a 2001 raptor 660 is the best. has remote res. just like the oem warrior shock.. its a direct bolt in.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By toe420
      Anyone here from BC? Where do you ride? 
    • By rjsummer
      I just bought a 1984 Suzuki LT185 ATV and am looking for the OWNER’S manual. ( not a service manual) 
      I contacted Suzuki Canada but they have no paper or digital copies in their archives. 
      Does anyone possibly have a digital copy they’d be willing to share? 
    • By Gtc4d
      I recently purchased a raptor 80 for my grandson for  christmas. I am trying to make sure it is running properly. i have rebuilt the carb and adjusted the carb idle then the mixture to middle of where it runs rough and it runs great for about a min or 2. then it stalls out. I can usually choke it and it will start so i feel it is lacking fuel. the fuel shutoff valve has been changed and i checked it for good fuel flow.  any ideas of what to check next. I am planning to vfy fuel float height tomorrow. I visually checked it by turning carb upside down when i had it apart and it looked level. any ideas are appreciated. 
       
      Thanks.
      Todd
    • By Callaway
      I am trying to diagnose a no spark issue with my 02 Big Bear 400 and I am really hoping it is not a CDI.  I have done the test on the stator and I believe that is faulty.  I ordered a new aftermarket one from a the jungle website and it tested bad right out of the box so I am waiting for a different one to arrive from an ATV parts supplier.  I started looking out of curiosity at CDI units and it seems if it is for a big bear you are SOL.  Kodiaks, no problem.  Big Bear. No such luck.  
    • By jordan_ATV
      I got a 2005 350 Raptor Special Edition and I'm dealing with a no start issue; the weirdest thing is when I'm cranking it fires and slows down showing signs of pre firing, smoke shoots out the carburetor every time it sparks. every electrical part (CDI, Rectifier, Stator, Coil) has been swapped out from previous owner, the top end of the engines all new and I cleaned the carb out, anyone got any ideas or similar problems, also is it possible to have a bad spark timing
×
×
  • Create New...