Quantcast
Jump to content

Recommended Posts

Posted

I need a little help here. I just bought a '94 160 cc Quadrunner and I really don't know anything about these. It stalls when it goes to idle. I can't turn the idle screw in any farther so I'm thinking it's the air screw. Can anyone tell me which screw is the air screw? Are there any other adjustments for idle? Also, there is a kind of plunger under the tank that you can pull in and out about a quarter of an inch. Can anyone tell me what that is? Any help would be appreciated.

Posted (edited)

if you can rev it high, i would spray some carb cleaner in there and see what that does.

is the plunger the choke ?

you may need a rebuild kit. you should check the needle and seat at the float too.

zuki carb 160.jpg

1.jpg

57d77342b98e8_zukicarb160.jpg.d6f3d3752e777528428f5d776cb9c4d1.jpg

1.jpg.89bf299370e2f32e16df7953c738abb6.jpg

Edited by oxidized_black
Posted

Thanks for getting back. The choke is mounted on the left side of the handle bars so I don't know if the knob I'm talking about is part of the choke or not. I don't think so but I will take a closer look tonight and maybe a photo and post again.

As to the idle, I can certainly clean the carb but what I'm wondering is if the fact that I just started using regular gas and the previous owner used high test might make a difference in how it idles. I can't use high test at today's prices so I will have to find a way to make it run smoothly on regular gas.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Joeguy
      After i did my rebuild it seems to not want to shift well. I think the cable is alright, and when it does shift its nice and solid. I have to basically use my hand to shift and i have to pull or push it very far, like max travel, to get it to shift. I also tried adjusting the clutch set screw. Any ideas where to go next, or maybe i should just grab a new cable to try.
    • By noticon75
      Anyone ride at in the north east Kansas area? Tuttle Creek, Milford lake areas, Topeka?
    • By logray
      Hi all, 

      I am wondering if any of you have a Clutch Starter gear from a 1988 era quadrunner 250 sitting around that you could get me a precise measurement of the outer diameter of the race the sprag engages onto, for me? I need to machine a damaged race down and install a hardened sleeve and need that measurement (it's on a different gear than the OEM one, so I can't buy and use a OEM gear). 

    • By Maxg_57
      Is anyone still active on this club
    • By Yamahahahaha
      I'm in the middle of repairing damage from the chain coming off of this from the previous owner. (I learned this is somewhat common on these for various reasons.)
      What are you guys using to either help keep the chain correct and on the sprocket or guarding your engine in the case that it comes off / breaks?
      Is there an upgraded guard that can bolt around the sprocket in replacement of the currently broken OEM alluminum?

×
×
  • Create New...