-
Similar Forum Topics
-
By Bobbles
Hopefully someone can help me out, I purchased a 350 moto4 2wd while I'm trying to fix a dying honda. I can't see the vin number as there was damage and a bar has been welded where I think the vin should be, The decals say 350 moto4 Huntaway, it has the square gear change low, high, reverse up on the left of the handlebars and it has three rectangle lights up on the dash. after googling I'm struggling to find anything called huntaway, Any ideas? Thanks.
-
By Jameya
You guys are my last resort. Got a 2000 prairie 300. Brand new battery, neutral switch, aftermarket carb, spark plug, silenoid, key switch. Fuses are good. No neutral green light, will crank if cross the silenoid, but won’t start. No power at the ignition switch or regulator. I’m thinking cdi box or starter relay. Anyone have any suggestions?
-
By Noti95
20241020_164625.mp4
Hi everyone i am coming from Europe and looking forward to join this community. I'm currently riding Kymco mxu300r which is the same bike as Brute Force 300 just different plastics.
Recently i came to a problem with this atv when accelerating near full throttle it suddenly lost power like i quickly released throttle but i kept throttle lever in the same spot. Since then it pulls off fine until you are past first 1/4 of throttle and then starts stuttering/misfiring. Same behavior when revving in neutral or riding. Cleaned and gapped spark plug but no better.
Could this sudden symptoms be from bad ignition coil and cdi or dirty carb? Carb was never cleaned before but i used stabil in gas when atv was not in use. Atv has 1000 miles carb on it is Keihin cvk32.
Sorry for longer post and thank you in advance.
-
-
By mattgoodwin
I'm repairing a 96 Timberwolf 2x4. Many years ago a dog chewed the wires that go from stator to the rectifier/regulator, and I've had to use the pull start ever since. Ive since lost the plug for the stator and on the wiring harness side. I'm ordering a new stator that will also come with the female plug that I need to fix it on the wiring harness side, but I have no clue in what position to put those 3 white wires(ones I'm holding with electrical tape on them) back into the new plug. Since they're all the same color, does it matter? Any info on this or pictures anyone has of their own will be very much appreciated.
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now