Quantcast
Jump to content

Recommended Posts

Posted

Hi.. have 85 sx 250... need to do valve timing but there is no "T" MARK ON FLYWHEEL OR F MARK for that matter.Does anyone know the degrees that valves close BTDC or is there anyother way to figure this out .There is a small mark forTDC...thanks

Posted
Hi.. have 85 sx 250... need to do valve timing but there is no "T" MARK ON FLYWHEEL OR F MARK for that matter.Does anyone know the degrees that valves close BTDC or is there anyother way to figure this out .There is a small mark forTDC...thanks

OK found after poring over the manual its 35 degrees.........

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gwbarm
      Have you ever been on the trail and your tire valve goes bad. No way to break down the wheel and replace it. A lot of you probably know about this already i had heard of it but never used one. Just punch out the old one insert and tighten down the nut
       

       

       

       
      So far it has worked very well.
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By P_syko
      I’m brand new to 4 wheelers and just bought a 1987 Yamaha Moto 4 350. It has good compression and fuel, but no spark. I’ve looked high and low trying to find how to test all the components of the ignition system, but can’t find anything. This has a new CDI box on it, but I suspect it might be the stator. How do I test the stator on this? Any help would be greatly appreciated! 
    • By carkivey3
      i just picked this up. was told ran fine but overheating issues led to replacing head gasket and head. has not ran since. he is not a mechanic but helped someone else who he could not get back to finish job, got aggravated and put up for sale. i was thinking timing issues. i have 110-120psi on all 3 cylinders so i think valves are correct. dont know about distributor yet. however i have no spark. i have no power going to ignition coil. tried to follow white wire but gets lost in wire harness. does anyone have a wiring diagram? can anyone tell me what conditions have to be met before starting. motor turns over so i would think all safeties are met but you never know.
    • By Gwbarm
      I finally got around to working on the TRX, this has been an ongoing problem with this machine. This is a machine that we keep on my Fathers property, i dont see it that often, my brother haad it professionally repaired last year and year before same problem, the new starter gears and bypass gears last about a year and the machine is not used that often, he said he was done with it , so i thought i should go take a look. Sure enough the gears were all malled again. 
       

       

      IMG_4910.mov   There is some slack in there but most is taken up by the gear cover,if anyone with history with these machines has had the same problem, let me know your findings. Where i am now im looking for finding replacement honda gears on Ebay and try those. I suspect the original was replaced with aftermarket gears years ago and they just worse quality as the years go by. 
×
×
  • Create New...