Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
I have a 97" polaris sportsman 500 and the 4 wheel drive wont work, it just didnt work one day. I dont know when or why it went out. It has a 4 wheel drive button on the handle bars and it is on and i have turned it on and off but no go............ any thoughts or ideas, please help. I need it for sat. i will never get out on this small lake for ice fishing with out my wheeler, thanks in advance jamie.
I have a 2007 Suzuki Eiger with camouflage finish. Over the years the finish has faded to a blue green color, its not as annoying as some that I have seen that faded to purple, but I still don't like it much. Im sure this has happened to others on the forum. Just curious what you guys do to fix this. I was thinking of mixing up some clear with a hint of yellow in it to neutralize the blue green but will have to do some testing to get it right. Any ideas would be greatly appreciated.
I have an 86 yfm250 (moto4 250) i picked up.
It bogs and pops a bit out the tailpipe if you can even get it higher up in the rpm. It is pretty gutless. I have other 250’s (timberwolves) and its ultra gutless compared to them.
It has an aftermarket carb on it that has a “W” on it Its not a mikuni but it looks close
i figured jetting was off at the high end.
i had a mimuni that was very crusty, swapped the main jet into the W carb, and the needle, which was set on low slot 4 so left it there.
it actually ran much better, and cured what i thought was a problem caused by a lean condition from the W carbs main jet being too restricted when i compared to the factory mikuni
I had it out and was enjoying the upper rpms that i couldnt reach before without bog. at wot it would fall on its face low top speed.
after getting it hot, it would actually refuse to start after dying.
back to the drawing board.
when i first got it i adjusted the valves. So i retraced my work and thought maybe id overtightened. double checked, nope all good. .005 exh , .003 intake, check.
So i checked the compression.
here is the trickyness. help me understand this. I am at 3500ft asl in calgary canada
- initiate test, it goes to 75psi right away. this is low. Even at my elevation im thinking 110psi minimum
but....this thing starts no problem. even -20c it starts. makes no sense to me. so i press the starter again and it goes to 85. Then i press it again and no change. Then i turn over again and it jumps to 95. Then again...no change. Then again and it goes to 115. finally finishes at 120 and i cannot get it to go any higher than this.
ive repeated this multiple times.
i press and hold the starter...it will max at 75. Then a series of maybe 10 more quick turnovers from the starter and compression inches up to 120psi.
So, i think the low compression explains the low top end, and even the backfiring out the exhaust when hot. The exhaust is rich enough (incomplete combustion in chamber) and to ignite in the muffler.
it gets worse when hotter.
makes me think i have a crack, or something that is low down on the cylinder wall. When the piston stops just above it on the upstroke, and i then turn it over again, it adds pressure to my tester reading.
Similar Tagged Content
Recently Browsing 0 members
- No registered users viewing this page.