ResQ91

So I just started tearing into wiring connections and found two w/high resistance. Thought I had it....... Got that squared away and find it was more than one thing. What would cause difficulty getting to Neutral with shifter. (Won't start unless in neutral) Seems like if I rock machine back and forth it gets there. TIA

Hi guys My 87 Bear 350 won't start and could use a hand. Turn key on and Oil light turns on and then slowly fades out. (I think this is key to this) No start, not even a tick. Battery and connections good A Solenoid post jump turns it over Neutral Safety Switch wire attached and seems good It has not had a wire/switch on Rear Brake Pedal ever since I had it. Any thoughts on some other things to troubleshoot this??

Hi Guys! New member and could really use your advice. I would have to believe this has been an issue for others but a search here came up with nothing......? (Probably me not doing search correctly) I have an 87 Big Bear 350 YFM350FWT The OEM Mikuni BTM carb is shot and would rather replace than rebuild. It is no longer made and I have had good luck with NICHE carbs so I ordered a #K-CRB-0006 This was what they said was replacement when ordered. This Carb only uses 1 Throttle cable. The Slide is linked so it uses one. (OEM had 2nd cable coming through top to move slide) Problem is when I ordered a replacement Cable from NICHE (#C-CBL-0061) the Cable wire is a little short, not allowing Throttle to return all the way down to Idle position. I called NICHE and they are at a loss. Haven't gotten back to me after 2+ weeks. What would you recommend other than a carb rebuild? Can I just use 1 of the OEM cables (It is the right length) and snip/disconnect the other that went to top of Carb for Slide? Or ?? Thanks in advance for any advice you have!! Dave