-
Similar Forum Topics
-
By Tuzz
Bucking started about a month ago and works ok after 1/2 hour warmup. Today while working on it i discovered that if i put the ignition switch in LIGHT position it runs fine right from the start.
I'm stumped! Any idea why this could be?
-
By Doublewidekings
I am looking for what you would consider the best ATV winch for under $125. Thanks in advance.
-
By Cobra_kai83
The gas in the tank was bad so I drained it and put new fuel in. It still wouldn't run so I took the carb out and cleaned it. Re-installed the carb and now it will only start and run under full throttle. It also runs rough like this. The engine stops running once I back out to 1/4 throttle. What the heck is going on?
-
By Bdubb0227
Hey guys, I'm new on here but I have a hell of a problem. I traded for a 98 timberwolf 2x4 and it ran good but smoked. So I decided to get piston and rings with new jug a and put everything together did the timing by the marks on the fly wheel and the cam gear and now all its is rolling over in the back fires extremely loud someone please help
-
By mhcchamp2023
Hi All,
When I get my foot off the throttle the engine brakes but the sound is not as it use to be = very loud.
The noise began (not sure it is relevant) after I have replace the 2 u-joints on the rear shaft (between the transmission the the rear differential) and engine oil change.
Important to say that when accelerating all sound and works perfect, the noise is only when I get my foot of the throttle.
Any idea what might be the cause?
Thank you.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.