paintapig

ball joints

3 posts in this topic

how do i put a new ball joint in the a-frame

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.


If it doesn't just unbolt from the a-arm, I think you need to get a new a-arm. What kind of quad is it? You might want to call a dealer service dept. and ask them if the ball joints are replaceable.

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.

What kind of atv is it? You do need to just see if it unbolts or is pressed in.

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  •  Like what you are reading? Please help us by sharing this content.
  • Similar Content

    • By toonces
      Just got this 700 grizz and I'm adding a hitch ball on the back just for the sake of having a good trailer tie down point. Not sure what I'd be towing with the bike in the future but I suppose I'd like to get whatever ball size would be most common on the things I'd be likely to tow with an ATV.
      So which size yall think would be best...1 7/8", 2", or 2 5/16" ?
    • By Rocky
      I just picked up a Big Bear 350 4x4, I was told it was a 1994 model. It runs and drives, but needs a bunch of work (I picked it up for a winter project). Anyhow, the front drive shaft is so loose that it falls right out of the splined u joint. The splines aren't worn out, I'll try to get a picture later on but it seems like the drive shaft is too short. It doesn't look broken or extremely worn, but when the pushed all the way into the rear u joint (by the engine) the front of the shaft is not even making connection with the front U joint and the shaft falls out of the front U joint. I can't figure out why it would be like that, the U joints don't look broken or worn (the splines look OK). The spring is still on the shaft up by the front U joint, but it's like the spring is pushing the shaft right out of the joint. Is there supposed to be something keeping the shaft from sliding too far into the rear joint?
    • By pachouly1956
      Is there such a thing ? What size is that damn thing ?
    • By madstuff33
      so iv been looking for new ball joints for my kazuma falcon 150. they are practically non existant apart from buying entire new suspension arms, i swear my hair is going white looking for these damn things. is there any suggestions as to alternative ball joints i can use or does anybody know if there is a company who stocks them?