Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Jack Perry

2001 Yamaha warrior getting nothing when trying to start

Recommended Posts

My 2001 warrior does absolutely positively nothing when trying to start anybody running into this issue please help thank you

Share this post


Link to post
Share on other sites


Welcome to QUADCRAZY 😛  I moved your topic into our Yamaha forum and added the year into your topic title. I used to have an older warrior 350 back in the day. So what actually happens, it cranks but never fires up? Start button work and engaging the starter? Use the website search feature at the top and you'll find similar topics like:

 

Share this post


Link to post
Share on other sites

I also have an 01 Warrior that suddenly wouldn’t start.  I’m having a difficult time finding a manual for this particular year so I can measure the stator resistance.  Replaced the ignition coil since the resistance was over 13k ohms but no improvement.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By jimybud
      Below is a quote from a response to similar question from yesterday: 
      "Easiest thing to check is trash in the main jet.  if it idles fine, then the idle circuit and low speed jet is clear.  if it bogs off idle that's when it's transitioning to the main jet." 
      I will go ahead and open up the carb and check the main jet, but please respond to this post as if the main jet is squeaky clean.
      Below is my post:
      Only starts and runs on Full chock. 
      Does not matter what position I have my "mixture" screw.   Tried it at zero, 1 turn, 2 turn, up to five turns.  Spent a few hours confirming that the position of the mixture screw does not resolve issue.
      Runs great at idle and if I slowly engage throttle, it will rev up as expected.  But, quick rev up or when I am trying to drive it, it spits and sputters and looses power.
      I also use a propane bottle and did not find any obvious leaks, and the vacuum port is hooked to fuel peacock and I also made sure to simply block the port with my finger to see if that would resolve the issue.
      New Carb (after market), New Coil, Fresh Gas.  No leaks at manifold boot, hot battery.  Good gas flow.    Runs too good to be a valve issue, or cylinder, great compression.
      I can move the choke out a tiny bit, and it will still run, but will still bog down when I try to power it up.
      I also have a 250 trail boss Polaris that I require to run at full choke, but it has power at all throttle potions.
      I suspect it is running rich as the choke is on, but will not run with it off.
      Any details would be appreciated.
    • By donerightautomotive84
      Ok so 2000 sportsman new.caltric carb new fuel pump new jug and piston new cdi and coil finally get to start it and itll idep for 5 to 10 seconds and die what am i missing people any help id love ya forever lol
      Sent from my LM-Q720 using Tapatalk
    • By Thehick344
      I have a 2001 650 quest that ran great. Shut it off, wont start. Got tinkering at a buddies, it ended up in a snowbank. Lost my train of thought since then.  I have a black, red, green  top with two plug in wires yellow and yellow and red I believe.. I have a new battery. Just dunno what to do. I tried hooking the wire coming up to the solenoid on the far side, then directly across I put the positive cable and it instantly started turning over without the button being pressed until I took the cable off.  The little black resistor box has also been eliminated.   Any help would be greatly appreciated.. 
    • By Halley
      Could anyone take a look at the picture and let me know if I’m needing to replace the actual throttle cable or the throttle handle ? Its for a can am 2018 outlander XMR 1000. It’s in limp home mode and throwing code P1619


    • By Gary Mier
      1997 Yamaha 350 Warrior, should there be oil in the stator area? Have a no spark situation.
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...