Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By Erik Plug
Picked up my first Brute Force yesterday. What should have been an awesome afternoon of riding turn a bit into a deception. As I was unable to really take it out for a test drive at the shop, I decided to buy it and agreed that I would take the test drive at home.
When giving full throttle I noticed that the Brute was choking and lost all of its powers. Faulty fuel pump most likely.
Called the shop and the are coming to pick it up and repair it and bring it back. Good service. Nevertheless feels a bit sour in the mouth as I was told it was a 100% good.
Need to have some patience I now before I can really start riding.
I had a quad fall in my lap a couple weeks ago. The only things I knew about it was it was a Kawasaki Bayou 220, was in pretty rough shape and was free. I couldn't say no to a fun little project. I've been looking a different ATV forums gathering quite a bit of info and decided this was the one I wanted to join.
Thanks to this forum, I found the VIN under about an inch of mud and cross referenced it to be a '98. It had been sitting outside for at least 5 years and was told it ran when parked, but had no brakes. Squirrels or mice had been chewing on the handlebar controls and it's generally just kind of beat up.
So far, I've gone through the carb (not near as bad as I expected), freed up the brakes (will probably need new cables), replaced the spark plug, air filter, petcock and put a new battery in it.
The gas tank had been empty and looked clean so I put some fresh gas in it and tried to crank it today. I got a neutral light, but the starter button did nothing. I tried pull-starting it and it wouldn't fire. I checked the plug and wasn't getting a spark. I started digging and found some potential issues and some definite problems.
I have a wiring diagram I found on here but it's just a picture or scan out of a book and hard to read. I don't see a reference to a black/yellow wire, which is my first problem.
First, it that a factory crimp? One of those wired looks like it goes to the connector in the 2nd pic. Is that just a spade lug type connector? I pulled on it with some needle nose pliers but it didn't seem to want to come off. In the 3rd pic, should there be a fourth wire?
I've read through and bookmarked the threads Andrew Baker and Arizona have going but I figured I needed to start with these obvious issues first. I have lots of pictures, so if there is something else you want to see, just ask. If I don't already have a pic, I'll take one.
By Tom Pavlak
Hi Everyone - Need some help.
Got a nice little 220...clean machine. wiring is a mess. I have a diagram however, the one I have has 4 wires coming from the ignition switch not 2 like mine. So, I cant trace wires properly.
There is a white one that runs to the Solenoid, and a brown wire...from the Ignition...I dont know where its supposed to go. Also, on the Solenoid, there are 3 wires..W to ignition, B to start relay and B/Y runs up to the front of the machine...and is not plugged into anything...and there isnt a "Mate" missing it. How do they plug into the 4 open shovels by the 20A fuse?
I'm pretty sure my Lights and start switch/Lights are correct.
Problem I cant get anything...new battery...cant get the start button to work, cant get any power to the lights or switches...so I know something is not grounded or..
Any advice would be greatly appreciated.
By colin james
View File 2018/2019 Polaris Sportsman XP 850/1000 Service Manual
This is the factory service manual for the 2018/2019 Polaris Sportsman XP 850/1000
Submitter colin james Submitted 08/01/2019 Category Polaris ATV
Similar Tagged Content
UTV Crap has introduced an alternator kit for the Kawasaki Teryx that quickly and reliably boosts your Teryx charging capacity. With an additional 60 amps, there is no more worrying about adding lights, stereos or heated seats.
UTV Crap Teryx 750 60 Amp Alternator Kit.
Smaller 60 Amp Alternator
Easy 1 Wire Hook Up
2 Cog Style Pulleys for Less Horse Power Loss and Less Stress on the Crank
Heavy Duty Cog Style BeltCustom Billet Crank Mounts
$474.95 Complete Kit Ready to Bolt on!
UTV Crap also has an alternator kit for the Yamaha Rhino for $349.95
About UTV Crap:
UTV Crap sells, manufactures and installs: parts, accessories and suspension kits for all major UTVs. UTV Crap is located in Phoenix, AZ can can be reached online at www.utvcrap.com or by calling 623.934.3070
Introducing the Dash Frame system for the Kawasaki Teryx from Black Rhino Performance. The Dash Frame fits nicely into the middle of your dash, and is designed to closely follow the shape of the Kawasaki Teryx dash. This frame puts your gauges and switches at the same angle as the upper dash for easy viewing of the gauges and convenient placement of switches. The panel provides mounting for 3 2"
I just picked up a 2008 Kawasaki Teryx 750 LE 4x4 and am looking for Wench Suggestions. It was used by an old man to check his mail and only has 30 hours on it! I intend to use this on my very steep property like a small tractor. I had a old Ford 1220 Tractor and with its high center of gravity and lack of 4 wheel drive it was useless!
To the point, I am looking a wench suggestions to help my new tool do its job! Even though the front bumper is drilled for a wench, I understand that I need a wench plate and that some wenches will not fit without body mods. Does 3500 Lbs capacity sound right?
Recently Browsing 0 members
No registered users viewing this page.