Application for employment
-
Similar Forum Topics
-
By shorty
So now this "new to me" Kowhockey has ANOTHER problem. Replacing the rectifier cured the charging problem, rode around for a while, Yahoo!.. but this morning it wouldn't start, hmm 🤔 checking for spark, nuttin.. CDI igniter module bad. It's not the coil because when the key is turned off the spark knocks me down. Glad I got this old quad cheap because I'm replacing lots of electrical parts. Also found 3 blown fuses in the toolkit. 😭
-
By SouthARriverRat
Looking froward gaining more knowledge and seeing projects being built. Currently resurrecting some kind of Suzuki 230 quad. I believe. lol. Been sitting at the edge of the woods for 15+ years. Riding a all original 84 Honda atc 110
-
By p5200
Hello folks, my machine wound up with I think water in the tank etc. It runs but speeds up and slows back down randomly. When not running I don't see gas dripping from the drain nipple on bottom of float bowl and drain screw is closed tight. With normal idle speed I see no leaking. When the idle speed increases quite a bit on it's own, gas appears to start slowly dripping from float bowl drain nipple? I'm wondering if the carb is flooding and the gas is actually coming from higher up and just appears, to be coming out of nipple but, is actually running down the sides of the nipple? I put a kit in the factory Mikuni carb last year after sitting for a while and I think the gas in the jug I used had drawn moisture. I plan to pull the carb tomorrow and clean everything out. I was just curious if anyone else thinks it's probably something in the carb and is, acutally a flooding problem? Thanks Folks! 🙂
-
By kawasig
Hello All
I have a 1987 Suzuki dual range 230 and a 96 bayou 220. I'm trying to figure what oil to use. I normally put Amzoil synthetic in most everything. But I understand there are concerns over the wet clutch. I've heard rotella 10w40 full synthetic,5w40 synthetic,10w30&40 non synthetic. I do live in Michigan, so temps cold and hot are encountered. It could be below zero or 90 degrees farenhight. I don't have manuals for them. Any help is greatly appreciated!

Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.