Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
Unfortunately I didn't notice some of the rust hitting the undercarriage of my 2004 Yamaha Grizzly 660, but saw it the other day when I was doing some maintenance, oil change, air filter, spark plug, etc. The left side footrest broke and that's causing the plastic to hit the front wheel. It broke right at the welds from too much rust. Looks to me like what I need is (looked this up on yamahapartshouse.com):
YAMAHA FOOTREST BOARD 5KM-27481-10 Left side (broken)
YAMAHA FOOTREST BOARD 5KM-27488-10-00 Right side (rusted and will probably break eventually)
Does anyone have a less expensive source? I did see on ebay a couple of listings but it still comes out to @ $50 each,
It appears that the Service Manual thread at top of forum is dead as all the links no longer work. I'm actually looking for service manual for a 2000 KVF300 Prairie that I just picked up. Does anybody have link to one that they can share, or know where I can find one? Thanks in advance for any help.
By Reece Bowen
x just bought this expedition 425 and the Speedo needle does not work. The lights work for the shift indcator. So is this an electronic Speedo or cable? Is there a way to fix it or will I have to replace the unit? Thanks for any help you can provide.
By My kiwi shed
Hi there everyone. Just seeing if there is advice on a problem I have before I start digging too deep.
I recently bought this creally nice 2004 King quad ltf300 with only 2400km..
Everything things works great except when engaged into 4wd or diff lock it has a clicking noise ( sounds like broken teeth etc) are the front diffs known to blow? Or the transfer from engine?
I am yet to test on some loose ground to see if I'm getting drive at front .
I will be driving in to find problem in next few weeks but thought I'd see if anyone might know what it is first. Cheers
Similar Tagged Content
By Christian Brindle
I have a 2000 Polaris Sportsman 500. The Speedometer got water inside of it and it sat for a long time. So now that speedometer is trashed to say the least and i need to find a replacement. I don't want to put up the cash for an oem one so i was wondering if anyone knew any good speedometers out there i could use. I've found many speedometers i like but don't know how i'd wire it up without the same connection points. Thanks, any input is appreciated
I was riding my 400ex one day and when i shut it off to put it in the garage i tried to start it put again to drive it into the garge and it wouldnt start.I put a compression tester on it and its like 30 psi with out throttle and 0 psi WITH THROTTLE.
when i put my finger over the hole it fell likes its pulling my finger in more then its pushing it out
Has good spark.When i took it into the shop the said it had 1oz of oil in it and a tiny pit of metal shaving(TINY BIT LIKE 30 flakes)
When i try to pull start (push start/roll start) it made a not normal sound and wouldnt stay running.
If my bottom end is blow why would it still turn over fine,
Are my valves siezed or not working properly
or is my timing off causeing valves to not open in correct order with fire
PLEASE HELP all help is appreciated
Bevinsee P15D H6M LED Headlight Bulb For Kawasaki ATV KLF220 300 KFX400 KVF300
I'm looking at replacing the headlamps on my 2001 KLF 300. These LEDs are out of my experience range. Supposedly they are "plug and play".
What problems am I not aware of? Other controllers, ballast?
I have brought an 84 TRX 200 back to life and unfortunately whomever dug into it first removed the two trim pieces that go around the gas tank. I was thinking someone on the site may have an old parts bike with these pieces lying around..... If so, drop me a message and we can make a deal. I just want to complete the bike!
By Connor Tuftin
I have a 1988 300 Honda FourTrax, All wheel drive.
My brother and I were fixing up this quad. We put a brand new battery and fuses in and it was running fine until we put the quad into reverse. As soon as it was put into reverse all of the electrical cut out and power wasn't making it to the head unit anymore and both of the brand new fuses popped. We figured there might have been a short from the starter or solenoids, but they are all working properly. At this point we don't know where to start looking for where the short could be. I'm just wondering if anybody has had the same issue or knows of similar issues that could cause these electrical shorts?
Recently Browsing 0 members
No registered users viewing this page.