Quantcast
Jump to content

Recommended Posts

Posted

The VIN's on these era Polaris' are only 7 digits. They went to a full VIN around 1998 from what I recall.

You can look up the VIN you have and identify the year make and model. I had a Blue 1995 Polaris 300 2x4 VIN 2563837 and the VIN record showed it was a 1995 Polaris 450 4x4 with a generic picture of a green 4x4.

The summary was that the VIN couldn't be used to order parts, only the make, model and displacement info. The motor Serial number didn't help either.

With a 7-digit VIN, there just isn't enough characters to identify much about the vehicle. You can't include many details other than mfg, year model.

As a matter of fact, just getting it Titled and registered was overkill because the VIN didn't clearly identify the year, make and model. 

 

  • 4 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Forum Topics

    • By noticon75
      Anyone ride at in the north east Kansas area? Tuttle Creek, Milford lake areas, Topeka?
    • By LashinWheeler
      Hello all, I have a 2006 Polaris Sawtooth with no spark. It has a dead battery but with a jump pack on it, it will still not Spark. Plug is good, Throttle ETC is not closed, Stator pick up coil seems to Ohm out in the correct range, Unsure how to properly check the CDI. And when ignition is on the Neutral and reverse light come on but after cranking just the neutral stays on. 
       
      Any help would be great,
       
      Thanks!
    • By Maxg_57
      Is anyone still active on this club
    • By cruteg8
      Does anyone know  the orientation of the bell crank for scrambler 400 2x4 it was not hooked up when I bought quad the way  i put it high goes into reverse and vise versa I flipped it 180 but that put  the shift rod at big angle and it just kinda grinds into gears so dnt think that is right either pretty sure it has to be the exact orientation and the rod adjusted accordingly but I cant seem to find it anyone knows please help 
    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
×
×
  • Create New...