Quantcast
Jump to content

Recommended Posts

Posted

So While not extreme, it is pretty loose (what we call bullrock here) scree going up my lower back yard.

The side shot is to give you an idea of the angle. (notice the trees are relatively vertical, so I wasn't leaning sideways):cute:

My CF800XC doesn't hesitate at all.

4high seems to work the best.

I've pulled it in 2 high with no real issues, just a bit of wheel spin.

4low is overkill right now (condition wise) and 4low with the front locker is nuts to hold onto.

anyway, this is part of why I bought an ATV I've drug 16 to 30 foot logs down this hill by hand.

Maybe ten to fifteen tons of stone for landscaping features and a cord or two of wood.

Figured a quad would make the trip up easier and getting logs down a HECK OF A LOT EASIER!

I've passed the break in mark and no complaints.

 

20220910_172736.jpg

20220910_172751.jpg

20220910_172800.jpg

oh yeah . . the top end of the upper backyard gets a bit steeper . .  :huh:

Didn't feel like walking up  there right now.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By p5200
      The studs in the sprocket hub are stripped out. The hub is probably walloed out also. Probably will have to have a new sprocket hub. I doubt I have the ability nor the tools needed for this job. Thanks for all suggestions/opinions! 

      20240225_155255.mp4   20240225_155255.mp4 20240225_155255.mp4 20240225_155255.mp4  
    • By WyattLemke25
      Having problems with the battery draining while riding. It has a new battery, it does have eps, a lightbar and a winch. Can ride it for an hour or more just fine, but eventually the battery runs down to the point it can't keep up with fuel injection and it'll sputter, limp, and die. It also throws codes for the throttle position sensor. I'm not sure if that is related or not. Any ideas? 
    • By Bennett
      I have this taotao quad four-wheeler all of a sudden my daughter was riding it and the clutch got loose and she can't change gears. I've tried tighten it up I've watched videos. I'm a single mother/father so I don't know what else to do to tighten it up can someone help me . This is the clutch. 

    • By cervenakrava
      Hi,
      New to ATV repair but willing to learn and get my hands dirty.
      We start the atv and even with a good battery, it will drain it very quickly and eventually the atv shuts down. Checking the battery afterwards shows significant drain on it.
      Would this be a shot alternator? Some electronics module?
      Thank you kindly.  Just need to be pointed in the right direction and then with a repair manual will get to it.
      Cheers
×
×
  • Create New...