Quantcast
Jump to content

Recommended Posts

Posted

I have 2001 yamaha Big Bear 400 4x4,recently bought it

It came with near brand new Maxxis Zillas 27x11-12's

They are a bit too agressive for our needs..we rarely go in any deep muc and mostly just our dirt road or the woods around here in Georgia

They tear our dirt road and yard up pretty easily

Whats a good tire for our needs?

Once i figure that out,,i will either buy new or offer a good trade locally

 

forgot to add a picture of it

bigbear.jpg

Posted

I like the round cross section tyres with the small square bumps, what around here would be called a sand tyre. They are what most of the bikes used to come with standard. The bikes track and behave better with tyre contact only  down the centre line, rather than the swapping contact point you get with wide flatter cross section tyres. The wide flat tyres also chew everything up as you say. The fixed back axle alone is enough to cause slipping between left and right, without it being compounded by slippage between the inner and outer side of each tyre. Those wide flat tyrs also put more strain on the wheel bearings and suspension, which a round tyre which has it's contact point right below the steering point doesn't.

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Suzukiquad
      Hi, I have been around everything with a motor since I was little, and finally purchased more to get my husband, and kids involved. I have 4 quads I will be searching around for information on. I have two 2002 Suzuki LT80K quads, a 1997 Yamaha Timberwolf 250, and a 1996 Kawasaki Bayou 220. I have had different ones throughout the years, and plan on buying another Yamaha Banshee. I plan on trying to learn more about all of them, so I can customize some of them. I know nothing about them besides how to race them, my dad always took care of the rest, but figured it was time for me to learn. 
    • By wanrep
      View File 2019-2024 Yamaha YFZ 50 service manual
       2019-2024 Yamaha YFZ 50 service manual
      Submitter wanrep Submitted 05/04/2025 Category Yamaha ATV  
    • By wanrep
      View File 2017-2018 Yamaha YFZ 50 service manual
      2017-2018 Yamaha YFZ 50 service manual
      YFZ05YYXH
      YF05RH
      Submitter wanrep Submitted 05/04/2025 Category Yamaha ATV  
    • By kawasig
      Hello All
      I'm kinda new to ATVs. I just bought a 1987 Suzuki quad runner 230 Dual Range. I'm having a problem finding info on it. It's very clean, only 2.800 miles. The front wheels are only 30 in.center to center. I was thinking about adding wheel spacers to give it more stability. I realize the added stress on ball joints and bearings. I'm wondering if there are any other concerns? Any input is greatly appreciated!
    • By Thumpinhard25
      First thanks for any help guys, new to the forums and it's gotten me this far. I bought a 2001 bear tracker 250 for my family to get around the dirt bikes races. It wasn't running right and had a high idle. Previous owner thought it was a carb problem, so he ordered a new Zoom carb and new intake boot, but it still had the same high idle. ( I believe he had the throttle cable adjusted wrong, because it idled fine when I put it back together) So I tore down and cleaned the stock carb, and it started up and idled fine, but needed to have the choke 1/2 out to run.  I swapped to the new zoom carb and had the same issue. Choke half out bike ran ok. I played with the needle and the pilot screw with no change. ( bike did seem to be running rich though, but didn't get better when I tightened pilot screw or raised meddle) I Took it to the races and once I started bouncing around in the cattle fields the quad started cutting out real bad. It would barely run.  Sometimes it would run with choke off, sometimes choke 1/2, sometime choke full. I cleaned carb again, checked float level, and boots, no change still wouldn't run. Then suddenly it started running ok again.  This makes me believe it's an electrical issue rather then carb. I know there's no air leak, it's been checked, both carbs are clean( I've swapped them out a couple times, it starts up immediately and usually idles fine. But then bogs down/ or stutters under throttle. I saw the post on the guy who disconnected his rectifier and reconnected and suddenly it started working again, which lead me to believe it may be electrical and not carb.  So any advice on what I should check? Any way to test the CDI or rectifier?  Once again, I appreciate your help.  
×
×
  • Create New...