-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
-
Similar Topics
-
By Atvguy0901
Thank for the add on quad crazy. I am new here and need some help with my atv. It’s a older Yamaha Timberwolf 250 that I purchased second hand from an person. I got it home ans started to look into it. He stated it needed a cdi box so I ordered one for it and a battery as well also a key switch cause it did not come with one. I put all the parts on it and when I hit the start button it just clicks and noting else. Thank you any help is appreciated.
-
By p5200
I seem to have no resistance at all on the rear brake pedal and no rear brakes. They were pretty good before I removed the right side crank cover. In order to get to the lower bolts of the cover, I took a piece of baling wire and wired the pedal in the down position. I assume, that caused at least, part of the brake problem. I can't see where fluid came out but, I did have to add more fluid. Added the fluid but still no resistance to pedal. Should I try to bleed the rear brakes? Thanks
-
By grinner
i cant decide on which one... the 450 has 499cc and 33 hp the 570 is 567 cc.... and 44hp... which is the better value? which is the better performer?
-
By Gwbarm
Still working on the 2000 Big Bear with a no spark issue. A lot of this has been covered in an older thread, but I will summarize.
Bought it with the previous owner telling me it needed a new wiring harness, but the wiring harness was in tact and seemed to be fine, except starter solenoid and coil was missing, also the engine was stuck, and no spark plug. Got the engine free and rotating, checked compression, it was 130, not great, but good enough to run. Hooked up a battery, nothing , went through all the wiring and found starter cutout relay bad, replaced that, now I have it rotating with starter. Pulled the plug checked, no spark. Checked start/stop switch, working like it should, reverse relay was bad ,replaced that. Checked continuity from coil to CDI, good, checked pickup coil resistance, within specs, checked anti kickback coil resistance, within specs. What am I missing.
-
By alexwv1863
Can anyone tell me if parts from either a 2000 or 2001 Kodiak 400 will fit a 04 Kodiak 450? I'm specifically needing to replace the fixed and sliding sheaves, and primary clutch and secondary clutch. I could be getting a couple names mixed up but that's the main parts currently. I'm looking on eBay and they look similar, if not identical, to what I'm needing to replace. I just don't want to buy parts and they be too small. Thanks.
-
-
-
Gallery Images
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.