Quantcast
Jump to content

Recommended Posts

Posted

I am looking into getting a Polaris outlaw, for sure i am able to get the 2006 model but I am working with the dealer on a great deal for a 2007 525 one. Does any one own one? Can I have any information from owners of one and how they like it, pros and cons... How is the IRS?

  • 2 weeks later...
Posted

I traded in a 2005 500 predator troy lee for a 2008 525 outlaw,the difference is unbelieveable. You should ride them both and decide. I would say after you ride a 500 outlaw and a 525 outlaw that your decision will be a lot easier to make. I really loved my troy lee 500 but the 525 is in another class as far as power goes.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Forum Topics

    • By PvtTarget
      Will not go into 1st but if ya go past will go into maybe next gear. Will not shift into reverse. I have see others say that the shift cam assembly dowel worn or fall out. How do I get to this? Do I need to break case in half?
       
      thanks for your help 
    • By Malta54
      I own a 2007 Polaris Sportsman EFI X2 model and have for the past months been experiencing loads of issues. Basically the Sportsman will only start if the throttle lever is pushed and will not remain on idle. This situation has persisted for months now and I have replaced the following parts:

      Sparking Plug
      Fuel Injector
      Fuel Pump
      Fuel Filter
      Fuel Valve
      Fuel lines
      Power Control Module

      The last part replaced was the Power Control Module and the Sportsman was tested and worked fine on a couple of occasions which were days apart so much so that some weeks later I took the Sportsman for an extensive ride and it worked perfectly. This was three weeks ago and today I tried to start the ATV it worked fine a few minutes and decided to switch it off so that I could continue with some prep work. A few minutes later tried to start it up again but noticed that it would only start if the throttle lever was pushed and once I removed my finger from the throttle lever the engine would not stay in idle and would simply shut down. Several attempts were made to start this and also tried to re-adjust the setting by turning the built in wheel like mechanism in the throttle cable but it was to no avail.

      The above have been repeating itself on an off basis. Each time a part is replaced the ATV would work and then all of a sudden will not keep its idle. At this stage I cannot think of any other solution other than possibly some sensors which might have an intermitting fault but I cannot really say.

      Would greatly appreciate any assistance.

      Thanks in advance.
    • By Zachary
      Hey guys I have a 99 xpress 300 and I'm having an issue, I rebuilt the engine and it will only start when I put my han over the intake on the car (when I manually choke it), I am not very familiar with plunger chokes.could some one help me understand how this choke is supposed to work and maybe how to ajust it so it works, thanks!
    • By paradiseestatesales
      Howdy, look forward to all knowledge available here
    • By Chucksta
      So.. it a weird one.. The quad surges as you go down the road. By the looks of my tracks, it's one wheel only. High range, low range, 2 wd , 4 wd.. It just doesn't matter.. 
      You can see in the pictures the marks it leaves. That was in a straight line, with hardly any acceleration. 
      Any ideas?



×
×
  • Create New...