Quantcast
Jump to content

Recommended Posts

Posted

everything sounds ok spark ok when it is out of hole exhaust has pressure and suction at intake but will not start or fire even with starting fluid cannt figure it out and can not find service manual download free do not know if timing is ok can not figure out how to line up marks with out instruction

Posted

I believe it will be on the left hand side as you are sitting on the machine. There should be timing marks on the flywheel. There should be a bolt that sits over top of the stator that you can take off and see the flywheel, there should be timing marks on the flywheel, there should be a "T" that shows up in the hole where the bolt goes, that will tell you that the motor is at TDC.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By docdoug72
      Has anyone had a suzuki 230 quad lock the engine up?  Its a well maintained bike, it locked up when my son was riding it. Pulled the plug, it has connected with the piston. I'm thinking the con rod let go.  I don't have a service manual.  Does the engine need to come out to check further?
    • By RGS
      1989 Moto 4 YFM350ERW intermittent spark.
      Quad has set for about 7 years and was running when parked.  When I replaced the battery and attempted to start it had no spark. 
       
      What I have done.  Followed troubleshooting in the manual. 
      1.       Coil failed the resistance check so I replaced it.  Still no spark.
      2.       I performed resistance checks on the stator and they all pass.
      3.       Found a bad rear brake stop switch and unplugged it and connected the wires in order to disable.  Now I have intermittent spark.  I believe that the issue is with either the stator or CDI and not sure which.
      1989 seems to be a transition year for electrical.  I can get new aftermarket CDI units for 87-88 and 90-94.  I cannot get ones for a 89.  I can get new stators for 87-89 and 90-95.  Looking at the schematics the wiring on my moto is closer to the 90 ones on the ATV side of the CDI and closer to the 87-88 on the stator side of the CDI.  Looking at part supply sources the stator housing is the same part # for all the years and looking at some of the stators on Amazon that have the dimensions on them both of the stators are the same size.
      What I am thinking of doing is to replace the stator and CDI with a 90-95 one as these parts are all readily available.   Does anyone know if this has been tried before and if there are any issues with doing this.  
       As a side note I also have a 1993 Moto 4 YFM350ER that has been sitting longer but it is located about 400 miles from me at this time.  By doing this change in addition to being able to get parts I will also have 2 ATV’s that are the same electrically. 
    • By wanrep
      View File 2019-2024 Yamaha YFZ 50 service manual
       2019-2024 Yamaha YFZ 50 service manual
      Submitter wanrep Submitted 05/04/2025 Category Yamaha ATV  
    • By wanrep
      View File 2017-2018 Yamaha YFZ 50 service manual
      2017-2018 Yamaha YFZ 50 service manual
      YFZ05YYXH
      YF05RH
      Submitter wanrep Submitted 05/04/2025 Category Yamaha ATV  
    • By Tinkeringreg
      Hi my name is Greg and I just acquired a free 2000 yamaha kodiac 400 4x4 with the ultramatic transmission that does not run. I plan to get it going and use it around my property

×
×
  • Create New...