Recommended Posts

I have an '04 Kodiak and an '03 Foreman S. The manual for the Kodiak shows 0-.39 inch tow in, the Foreman manual shows a 3/4 - 1 1/2 inch tow out. I have noticed my tires wear like they are being torn. I have just put new tires on the front and would like to get this correct to get the longest life out of my tires while getting the best handling. It seems to me that the settings for the Kodiak and about what should be for the Foreman S to get the best wear and handling. I suspect the Foreman service manual is incorrect. Any help would be appreciated.

Bill

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  •  Like what you are reading? Please help us by sharing this content.
  • Similar Content

    • By dirtybear00
      I have a 2000 big bear 400 manual shift. Does not have a shift lever on gender like a Kodiak has left foot operated rn12345 on left foot lever. I replaced the stator and pick up coil and now it is difficult to shift. I marked (indexed) the lever, rod and pivot clamp prior to removal and not sure where to go .  Maybe a clutch adjustment ? Anyone have a manual for this model ? I was sent a manual but it is for a shiftless Kodiak yet it states big bear as well 
    • By gadawg31
      I have searched all over and can't find anything on how to adjust the valves on my sons 2007 Polaris sportsman 90. Has anyone done this? Anyone have a manual for the 90 showing how to do it? I need to get this done pretty quick, since he has a ride coming very soon. Thanks.
      JD
    • By dglover1226
      I have a 01 raptor and recently had to bore it out to a 686 because it sucked in a bunch of sand. Now I have no torque or power in the first third of the throttle. I am hoping that someone else knows what is going on with it
    • By Vinsonary
      Ok everyone, I've been rebuilding the top end of my vinson 500 and here is my problem. After replacing all the gaskets and getting my timing set I was all set to place the head on when I realized I had left one of the two small sleeves that position the cylinder head on the base. To go back and put it in would require another complete tear down. This is one of those round cylindrical tubes that the jug sits on. All bolts are in along with Indian head gasket shellac on both sides of the gasket, my question is what might it hurt if I don't put it back in? Honestly I can't see where it will matter and setting the timing on this machine is a real bitch. Anyone have any thoughts on this?
      Sent from my iPhone using Tapatalk
    • By shanes1031
      Im loking at buying this atv, owner said when he put in gear and drove it that it made a grinding noise so they parked it, said he has the rear end off but hasnt taken it apart yet, sounds like bearings any other ideas? Very nice shape can get for 600