Quantcast
Jump to content

Recommended Posts

Posted

This was the question I had and hear from a lot of my buddies. I have a 05’ Yamaha Kodiak and am an avid hunter, fisherman, and general outdoorsman. A few years back I was looking for a quality ATV rear rack bag. Make a long story short, I bought one that fell apart almost immediately. So a buddy and I decided to create our own. Some of the cooler features are an integrated strap system, an internal weight bearing aluminum frame, and an exterior MOLLE system for accessory bags and utility holders. We call it the Quartermaster. We have produced several prototypes and we are about to start manufacturing them. What I would like is your help in scrutinizing it. Tell me what you would want if you were to “build” an ATV bag from scratch. Some of the accessories we are working on are an internal cooler that self-drains, different saddlebags with cup holders and a small cooler, a bag that can be attached to the back with an ATV cover attached to the inside so you can just pull and it comes out the right way. If you would like to see the bag we are working on and give further feedback you can go to Gear Freak Tough, Tested, True > Home or Gear Freak | Indiegogo. Thanks everyone.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Forum Topics

    • By Kaz
      Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
    • By geezer99
      I have an Axis 500 made by Hisun.  I uses a solid rear gearbox with no differential action. 
      I would like to convert this to a true differential with locking ability.  I've searched all over trying to find a source with no luck.
      Has anyone done this before, or know of a source? 
      Thanks,  Tom
    • By Need-help-with-quads
      So my moto 4 is smoking white smoke and when I go to first gear and get about half throttle there’s no power and it sounds like it’s bogging
    • By qcm413
      Hi,
      Thanks for a newbie on this site !
      i have grinding noise in my front differential. the front right wheel is turning and the left is try to turn but no movement and make sound like a gear broken. somebody have any idea ? not enough oil in diff ?
      thank
    • By mga
      on my left brake handle (for the rear brakes) there's two wires attached to it. What are these wires for? They can't be for the tail light, since it only has on filament  I tried to trace them, but i got lost in the harness. I checked wiring schematics, but didn't see anything like that.
      I'll post a pic later.
×
×
  • Create New...