-
Similar Forum Topics
-
By Bobbles
Hopefully someone can help me out, I purchased a 350 moto4 2wd while I'm trying to fix a dying honda. I can't see the vin number as there was damage and a bar has been welded where I think the vin should be, The decals say 350 moto4 Huntaway, it has the square gear change low, high, reverse up on the left of the handlebars and it has three rectangle lights up on the dash. after googling I'm struggling to find anything called huntaway, Any ideas? Thanks.
-
By olddude
Just wondering where you guy's an Gal's get your parts. I love buying OEM stuff but sometimes they just cost to darn much for what they are. I know, I know everybody needs to make a living but dang! $ 97.00 for brake pads on one side of the front of my KingQuad. There has got to be a better way.
-
By BuckBilly
Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Let's see if we can make this a daily event.
-
By DaveswMN
Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!!
Drove about 100 yards, ran about half throttle wouldn't idle. Put on somenew parts, jug/piston and rings, carb and valve seals.
'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
Thanks for any thoughts.
-
By Jameya
You guys are my last resort. Got a 2000 prairie 300. Brand new battery, neutral switch, aftermarket carb, spark plug, silenoid, key switch. Fuses are good. No neutral green light, will crank if cross the silenoid, but won’t start. No power at the ignition switch or regulator. I’m thinking cdi box or starter relay. Anyone have any suggestions?
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now