Quantcast
Jump to content

Recommended Posts

Posted

2000 Bayou misses out about half the time.

I have done the following

Cleaned the Carburetor.

Replaced the plug and check the plug wire, its wire, Checked the plug boot it ohms out at 500 ohms

Motor has 125# compression.

I did find a barked place on the pickup coil wiring coming out of the motor case.

I pulled the cover and ohm the pickup coil. It ohms at 470 ohms. I repaired the barked insulation and reinstalled.

I replaced the igniter with a new one.

I was told that the voltage regulator could be the problem so I unplugged it and made made sure the battery was fully charged and started it and ran it off the battery only. Still misses out.

I added a jumper wire to ground on the igniter to make sure there was not a bad ground somewhere. I also added a hot wire to the igniter to be assured that the key or kill switch was not the problem.

Nothing I have done has corrected the problem.

Attached is a video. Note: the video camera does not show what the human eye sees. The timing light does not light when it misses but the human eye sees that it is dim during the times the video shows it not flashing.

[ame]https://www.youtube.com/watch?v=QlSE7bIhWI8&list=HL1396568821[/ame]

Any Help any of you guys or gals can give me will be appreciated.

Thanks

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Mikey509
      Hi guys, I was given a 2000 Honda Recon fourtrax 250 (I think that's the full name lol). The previous owner had it sitting for a while before I got it. It sat for another few years in my ownership. I got it up and going on its first test drive today!! I was wondering where everyone buys their parts from?  Coming from the car community, we have sites like RockAuto and many more. Anything like that for quads? Also would like to be pointed in a direction, if possible, for plastics. I am missing a few and would like to have it complete. I appreciate any input!
    • By rjsummer
      Just some friendly advice on new tires. Check with your ATV dealer. 
      There are so many aftermarket sites, Revco, Royal Distributing, Partzilla, and on and on. Even with their “ big sales”, my local Canam dealer’s REGULAR price beat the tire prices of the 3rd party sellers! People often assume the Dealership will cost them more, but I found this not to be true!
    • By marlon smith
      1990 kawasaki bayou 300c idles fine but pops out exhaust and intake when trying to excel, will not take throttle past 1/4 , any one had this problem?
      have replaced carb twice, same thing, fresh built engine cylinder head, same as before, new spark plug, flywheel key is good, pulser test good, good spark
    • By kawasig
      Hello there
      I'm having a problem finding a quality carburetor for a 1993 Suzuki Quad Runner lt-f 250 2x4. I find a lot that have 3-4 star ratings. And all so far don't have the right throttle Cable inlet at the top. The last one I got 4 star on Amazon has a threaded cable sheath rest that could be partially drilled to work. I would prefer to get one I don't have to modify. Any recommendations are greatly appreciated!
    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
×
×
  • Create New...