Quantcast
Jump to content

Recommended Posts

Posted (edited)

I have been starting my Kodiak all winter to make sure the battery was charging. I took it out on a ride last week 7 parked it. Went out today to go for a ride & when I tried to start it it made a buzzing noise when I pushed the starter button. It was in neutral & I put it in park & still no luck. I then put it back in neutral & it started. I turned it off & tried to start it again & it made the buzzing noise. It won't start now. The buzzing noise is coming from the left side off the atv on the back end. That is when I was sitting on it. Any help would be appreciated.

I have taken my seat off & believe my problem is the starter solenoid. It has a 30 amp fuse & a spare fuse with it. The fuses look good. I also checked the starter fuse & it seems to be good. Any help please. Would like to ride tomorrow. Thanks

Edited by Muzzlegirl
Posted

with a sxrewdriver, try crossing the two posts with it, it will spark, but if it turns over, it is the solenoid. you could try to clean the connections there with sandpaper and add some dielectric grease to keep the connection clean, or vaseline (petroleum based)

  • 3 weeks later...
Posted
I have been starting my Kodiak all winter to make sure the battery was charging. I took it out on a ride last week 7 parked it. Went out today to go for a ride & when I tried to start it it made a buzzing noise when I pushed the starter button. It was in neutral & I put it in park & still no luck. I then put it back in neutral & it started. I turned it off & tried to start it again & it made the buzzing noise. It won't start now. The buzzing noise is coming from the left side off the atv on the back end. That is when I was sitting on it. Any help would be appreciated.

I have taken my seat off & believe my problem is the starter solenoid. It has a 30 amp fuse & a spare fuse with it. The fuses look good. I also checked the starter fuse & it seems to be good. Any help please. Would like to ride tomorrow. Thanks

I have the same issue.....have you found your problem??

  • 2 weeks later...
Posted

Check your battery voltage - keep your volt meter on the battery when you hit the starter button. Drop of 2+ volts without the engine turning over and you've got a dead cell. Try jiggling your connections at the battery, corrosion there at a tight connection will keep it from starting and cause the solenoid to buzz.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
    • By Mister907
      Hi guys, I have a 2004 big bear 400. Last winter while plowing the driveway, I heard a loud pop from the left side of the engine. It continued to run as I looked for leaky fluid, but then died shortly after backing it up and won’t start now. The oil light comes on when I try to start it, no noise or anything else. 
      No blown fuses that I can find.
    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By Jdeaton011989
      Hi all. I have a timberwolf 250 2nd that will not start.. I thought it was out of time bc the guy I got it from said it just quit on him. The tensioner had a nut welded to it and it was like2 teeth off. I installed new tensioner and chain and it still will not start. It has fire and it will not hit off brake cleaner. It has compression. Haven't put a gauge but I'm sure it will crank and run with what it has. I double checked my work and it's still in time. Spot on. Both valves move. I'm about to put a feeler gauge on them and I'll cone back but other than that any ideas?
×
×
  • Create New...