Recommended Posts

'02 300 EX with fresh topend. .030 over bore with wiseco 12.5:1 piston. bike runs great. plastic and tires are good. its red and black. new bearings and seals in rear end and brakes. also has a AJS double bearing carrier in it for the axle brand new.head has been studded instead of head bolts.andhas a complete DG exhaust and carb has been jetted

looks nice and runs great $2200 firm. call 812 620 2064 for details. im in southern indiana.ask for rob

300e.jpg

300.jpg

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  •  Like what you are reading? Please help us by sharing this content.
  • Similar Content

    • By priglmeier
      I own a 2002 Can-Am Quest 650.
      It will start if you massage the throttle a bit and it will continue to run. BUT if you let go of the throttle and try to let it idle it will always die warm or cold.
      It has Non-Oxy premium gas, a new gapped NGK plug, a new carb (as of today) and fresh fluids. After installing the new carb it runs exactly the same.
       
      I only have a few things that I have observed since the new carb:
      The choke still doesn't do anything. It has a good cable and it is hooked up. It on fully off. There is a cable in the top, front of the engine that splits into two connectors. The connected side is in the photo. The other side has the yellow banded section and is not connected. I do not see anything in range of this connector so I don't know if this is normal or not??? The original carb wasn't really dirty or clogged. I'll use it as a spare. I don't see this cable and connectors listed in the Can-Am shop manual. Looking for some help. I want to ride!


    • By sloundez
      Does anyone out there know where I can get a functional pair of wheel cylinders for subject ATV? Any suggestions welcomed. Thanks
    • By marcuslachance
      I
      I bought a Honda 250sx 1986 but the exhaust is broken. Apparently it's not possible to order a new one. I checked to order one on others compagny but there's noting.
      Do you know which exhaust it's possible to install. Is there a company who sold an exaust to fit on my 250sx.
      Sorry for my english
      Thank you
      Marc
    • By Npeters
      Im working on a old 1987 honda 125 4 wheeler in the school shop. It will start by getting pulled by another 4 wheeler but wont start with the pull start or Electric Start. When you pull start it it tries to start but when you try the electric start it just turns over but doesnt even act like it wants to start. The spark plug is dry and it shoots fuel out of the back(air filter side) of the carb. Weve had the carb off twice and it is complety clean. What are some things we can try?
    • By bodatiouskid
      Have a 2002 Polaris Sportsman 700 that only has 34mi. on a carb & ring job.
      Cut the gas off today to drain carb.Now engine will not idle.If I open throttle will run,but let off & will cut off.Can screw idle in with no change.
      What happened? Why did this happen when fuel ran out?
      Please help me,my ATV is a daily driver.
      Please help!!