Quantcast
Jump to content

Recommended Posts

Posted

I just bought my first arctic cat. I changed the oil and filter. Now my atv smokes only when u rev the engine. Smoke looks white grey.. slight light blue tint.. when it. Idles it doesn't smoke.. Any body have a clue what is going on. The dealer said it's not the rings.. it has the 700cc suzuki engine..

Posted

when ones burning oil it will smoke when you get on it, or smoke worse then, its usually the rings or valve seals. it could be a bad gasket, clogged crankcase vent, but its usually rings or valve seals or both, I just sold a arctic cat with a 650 kaw v twin with just over a thousand miles that did the same thing, I sold it cheap as is because the last one I had that did that, a Suzuki quadmaster 500 with 1700 miles, cost me so much to fix,

Posted

Thanks Bayou Bill.. what's really wierd is that it started after I changed the oil. Th eoil was black. I just bought it. It. Didn't smoke prior to oil change. It only smokes while I rev the throttle a couple of times. If I just rev it steady from low to high it doesn't smoke.. weird. . U would think the rings would smoke all the time... the smoke isn't all that blue. It's more of a grey color. Like seafoam look when u add it...

Posted

I buy quads and fix them for resell in my spare time, I have bought several that had clogged carbs, valves out of adjustment, etc, that would idle all day without smoking, but when I clean the carbs, or whatever and get them to really run, smoke when you get on them, some a little, some bad, the quadmaster 500 would idle fine with no smoke but when I got it running right it smoked like a tar kettle, only on acceleration though. I had to replace the rings, piston, cylinder, they were all wore out, I put new valve seals in it too and lapped the valves, but the problem was the rings and cylinder, the nickel plating was worn through in one spot and the rings had around half thickness from new. in general in a car the rings will smoke when cold and get better when hot, and vice versa for the valve seals but ive found quads don't always work that way. anymore if I get a smoker after I get it running I sell it cheap even if I lose money on it. of course if I had a quad I wanted to keep and wasn't worried about profit I would fix it.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Popular Now

  • Similar Forum Topics

    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By Mikey509
      Hi everyone, first and foremost, I want to thank everyone for all the help I've received. I am so glad I found this community. I also wanna apologize if I'm spamming the forum, I come up with questions as I go, I guess lol. So when I got my Recon, the air box was missing the lid, held together by zip ties, and the filter was ripped and nasty. I have since ordered a new air box assembly. It comes with everything: the box,  lid, and filter ( the insert and the foam), and all the hardware necessary. This is the first time I've seen a metal filter inside a foam filter lol. However, my question is, I have read that you have to oil these filters? Every time I read it, it was always skimmed over, and I could not remember where I had read it. Is there a certain oil needed for this? Is the filter washable and reusable? Do I just stick the filter in oil, lol? Sorry if it sounds like a dumb question. Thanks in advance, y'all!
    • By Mikey509
      Hi guys, I was given a 2000 Honda Recon fourtrax 250 (I think that's the full name lol). The previous owner had it sitting for a while before I got it. It sat for another few years in my ownership. I got it up and going on its first test drive today!! I was wondering where everyone buys their parts from?  Coming from the car community, we have sites like RockAuto and many more. Anything like that for quads? Also would like to be pointed in a direction, if possible, for plastics. I am missing a few and would like to have it complete. I appreciate any input!
    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
×
×
  • Create New...