Quantcast
Jump to content

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By gordonmacritchie
      on my honda trx 500 we have no power to the ignition switch for starting or ignition
      we have lights and horn working
      all fuses are fine
      have traced through the harness and cant find any broken wires or bad connections
      from what we have gathered so far the pgm fi unit is not sending any power to the fuel pump relay to power everything up.
      if we put power direct to the ignition switch plug then everything works but wth the key in the off position.
      does this sound like a faulty pgm fi unit?
    • By Admin
      View File 1986-1989 Honda TRX350 Fourtrax TRX350D Foreman service manual
      1986-1989 Honda TRX350 Fourtrax TRX350D Foreman service manual
      Submitter Admin Submitted 03/08/2026 Category Honda ATV  
    • By Gtc4d
      I recently purchased a raptor 80 for my grandson for  christmas. I am trying to make sure it is running properly. i have rebuilt the carb and adjusted the carb idle then the mixture to middle of where it runs rough and it runs great for about a min or 2. then it stalls out. I can usually choke it and it will start so i feel it is lacking fuel. the fuel shutoff valve has been changed and i checked it for good fuel flow.  any ideas of what to check next. I am planning to vfy fuel float height tomorrow. I visually checked it by turning carb upside down when i had it apart and it looked level. any ideas are appreciated. 
       
      Thanks.
      Todd
    • By toe420
      Hey everyone, I just picked up a 91 trx350 4x4 with a blown top end. I don't know what happened to the poor thing but the cam journals that were round are oval shaped now. I also bought a running engine from a 92 trx350 4x4 to swap into the 91. Is there anything in particular I should be checking while the engine is out and I have good access to it and the frame? 
×
×
  • Create New...