Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Thehick344

2001 650 quest solenoid question

Recommended Posts

I have a 2001 650 quest that ran great. Shut it off, wont start. Got tinkering at a buddies, it ended up in a snowbank. Lost my train of thought since then.  I have a black, red, green  top with two plug in wires yellow and yellow and red I believe.. I have a new battery. Just dunno what to do. I tried hooking the wire coming up to the solenoid on the far side, then directly across I put the positive cable and it instantly started turning over without the button being pressed until I took the cable off.  The little black resistor box has also been eliminated.   Any help would be greatly appreciated.. 

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Bryzan3
      Looking for advice on what to try next I bought this quad and it’s has spark and fuel but won’t stay running only fires when I hold the starter button in even when spraying gas into the carb it still dies right away oil was milky white so I was thinking it maybe went under water 150 psi compression so I might be wrong but not a head gasket I am stuck Cause it should stay running with the straight gas through the carb so what should I try 
    • By Bryzan3
      Looking for advice on what to try next I bought this quad and it’s has spark and fuel but won’t stay running only fires when I hold the starter button in even when spraying gas into the carb it still dies right away oil was milky white so I was thinking it maybe went under water 150 psi compression so I might be wrong but not a head gasket I am stuck Cause it should stay running with the straight gas through the carb so what should I try 
    • By jimybud
      Below is a quote from a response to similar question from yesterday: 
      "Easiest thing to check is trash in the main jet.  if it idles fine, then the idle circuit and low speed jet is clear.  if it bogs off idle that's when it's transitioning to the main jet." 
      I will go ahead and open up the carb and check the main jet, but please respond to this post as if the main jet is squeaky clean.
      Below is my post:
      Only starts and runs on Full chock. 
      Does not matter what position I have my "mixture" screw.   Tried it at zero, 1 turn, 2 turn, up to five turns.  Spent a few hours confirming that the position of the mixture screw does not resolve issue.
      Runs great at idle and if I slowly engage throttle, it will rev up as expected.  But, quick rev up or when I am trying to drive it, it spits and sputters and looses power.
      I also use a propane bottle and did not find any obvious leaks, and the vacuum port is hooked to fuel peacock and I also made sure to simply block the port with my finger to see if that would resolve the issue.
      New Carb (after market), New Coil, Fresh Gas.  No leaks at manifold boot, hot battery.  Good gas flow.    Runs too good to be a valve issue, or cylinder, great compression.
      I can move the choke out a tiny bit, and it will still run, but will still bog down when I try to power it up.
      I also have a 250 trail boss Polaris that I require to run at full choke, but it has power at all throttle potions.
      I suspect it is running rich as the choke is on, but will not run with it off.
      Any details would be appreciated.
    • By Michael Thornton
      Why does the 2001 grizzly not have com bearings or something to protect the head.
    • By Spike976
      So I dug my warrior out of storage replaced the carburetor with one off Amazon & it was running great. Last week it didn't want to start it would crank & I could smell gas but nothing. I replaced the starter,stator,solenoid,spark plug & coil & resistor but still not starting. Checked the stator and its at 30 ohms tried using starter fluid but nothing. I am completely lost and could use some help thank you
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...