Best Rear suspension for a 94 Honda four Trax 300
.thumb.png.538ed68bd1a0b25fcc8d85287f5d96e5.png)
-
Similar Forum Topics
-
By tds7
Do any have any experience replacing 2001 Big Bear 400 Front Differential Input Shaft bearing and seal. Getting ready to buy one but the seal and bearing are bad. Any help would be appreciated.
-
By Usmc0861
Hey everyone, thank you in advance for any information shared. I have a 99 yamaha beartracker 250 that I am restoring (not to oem specs). I am having trouble finding suspension parts other than ball joints. Does anyone know where i can find shocks/springs for this atv? Are there other yamaha atvs that have interchangeable parts? Or what options might i have. I typically use this quad for hunting, getting around the farm, and trailriding. Thank yall again for any info.
The trailriding includes moderate hill climbs, creek beds, and wet/dry trails
-
By Matman
Been working on this teardown for a while. Special tools are needed in a few key areas such as Flywheel puller, Crankshaft 52mm wrench, wet clutch puller, etc.
I'm trying to get the wet clutch off now, and a few videos out there show it sliding right off.
Mine isn't that easy.
I measured the clutch's female threads and determined the puller spec needs to be 37mm x 1.5 LH Male.
Anyone come across identical pullers from another mfg?
The Suzuki tool is tough to track down and expensive for basically a slide hammer-type puller.
Just need to figure out anther way to remove the wet clutch without applying too much pressure on the clutch plates to bend/break the plates or base. All thoughts are welcome to homemade tools. After this I need to cut out my own 52mm end wrench for the opposite side of the crank!
-
By Forestrail
I've got 43 miles on this machine traveling on national forest trails, whoopdedos, banks, rocks ,tree branches makes for challenging riding. My last quad was Polaris sportsman 450 , rode like a cadillac. This cf moto does NOT cushion anything, springs are hd and are adjusted to minimum resistance and 4lbs air psi in tires! Its beating me up! Dealer says nothing available and atv powersports guy in town sid same thing because its Chinese. Japanese parts no problem.
Anybody have any thoughts or product out there. Longer shocks? IDK.
Thx in advance, Michael
-
By Dunedude
So I got a raptor 700 and I’m looking into building up the suspension for hitting jumps. Im mainly a dune rider, was thinking +4 swinger +2 a arms and axle with elks shocks. Any input or advice is greatly appreciated. Thanks!
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.