Quantcast
Jump to content

Recommended Posts

Posted

I'm assuming, it's alright to test the engine after adjusting valves without the rear axle installed? Can someone please verify this? I'm waiting on axle parts and wanting to get that done while waiting. Thanks! 🙂

Posted

Yeah it should be no trouble. I'd take the chain right off to make sure it didn't somehow mysteriously get drawn around and perhaps bunched up near a crankcase doing some damage. You'd want to keep on eye on ventilation and  on the temp if it's in some place without good ventilation.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By HHurks
      Yesterday I got a UForce 1000 as my first bike and I am wondering if there are any owners that could advise where I can find budget parts and accessories for it.
      I tried looking StarknightMT, but the filtering is a bit unreliable, so direct links or exact names are much appreciated.
      I'm mostly interested in sliders and side cases, but any advices for "must haves" are welcomed.
      Thank you!
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By tflack500tbx
      Background,
      This winter (Dec.) I was plowing and everything just died, just quit.  No lights, no pull start, No nothing.  I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this.  So I changed it again, thinking this was the same problem.  Tried to start it and a small pin hole in the CDI appeared with electrical smoke.  
      Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues).  I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.  
      Went to start it and the solenoid rapidly clicked.  All the dash lights on, headlights work.  Pull stared it and it fired right up no issues.  Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery.  Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good.  Pushed the starter button and it fired right up ran great.  Turned it off to test it again, Turned the key and nothing.  No dash lights nothing.  Took the jump box off and pulled started it.  Started it right up.  Re-hooked the jump box, still nothing.
      Any Ideas? 
    • By digrig
      Hey everyone,
      I’m having an issue with my 2021 Polaris Sportsman 570 – the engine keeps stalling after running for about 10–15 minutes. I’ve checked the air filter, spark plug, and fuel lines, but can’t seem to find the root of the problem. It starts up just fine, but then loses power suddenly.
      Has anyone experienced a similar issue with this model/year? Would appreciate any advice or troubleshooting tips you’ve tried that worked. Thanks in advance for your help!
×
×
  • Create New...